Overview
The Bilstein 11-176015 is a billet aluminum reservoir mounting clamp from the Bilstein B1 line. It secures a shock reservoir to the shock body so the reservoir stays where you set it, including during off-road use. Bilstein designs it to work with its 5160 and 5165 Series shock absorbers.
The clamp splits into two separate pieces, which makes it easier to fit around the shock. Two heavy duty stainless bolts hold the two halves together.
Key features
- Billet aluminum construction
- Two-piece design for easier installation
- Two heavy duty stainless bolts connect the halves
- Built for Bilstein 5160 and 5165 Series shock absorbers
- Holds the reservoir in position during off-road use
Reservoir placement and clamp care
A reservoir clamp carries the load of the reservoir during hard landings and hard climbs, so its fit matters. Position the reservoir so the hose runs in a smooth, unforced curve and keeps clear of tires and rocks. Tighten the clamp evenly, alternating between the bolts so the halves seat together without gaps.
Billet aluminum holds up well, but grit trapped between the clamp and the shock body can scuff the finish and accelerate wear. Clean the contact surfaces during every service and recheck the bolt tension after the first few drives. Stainless fasteners resist corrosion, yet any bolt that backs out should be inspected before it is retightened. Replace the clamp if it cracks, deforms, or no longer holds the reservoir firmly.
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 11-176015 |
| UPC | 651860665580 |
| Product line | B1 reservoir clamp |
| Material | Billet aluminum |
| Fasteners | Two heavy duty stainless bolts |
| Compatible shocks | Bilstein 5160 and 5165 Series |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit clamp, so it is not tied to a vehicle year, make or model. Fit depends on the Bilstein 5160 or 5165 Series shock it mounts to and the reservoir you run.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fit the two halves around the shock body and secure them with both stainless bolts. Because the clamp holds the reservoir in place, tighten both bolts fully before driving off-road.
What’s included
The clamp in two pieces, joined by two heavy duty stainless bolts. Not included: the Bilstein shock absorber and reservoir the clamp mounts to.









