Overview
The Baer Brakes 6805145 is a 10lb pressure residual valve with -3AN male inlet and outlet fittings, machined from billet aluminum with a black anodized finish. A residual pressure valve holds a small amount of line pressure in the brake circuit, so fluid does not drain back toward the master cylinder when it sits at or below the calipers.
Pressure residual valves are designed to maintain a small amount of line pressure needed in certain situations. The 2lb valve is used with disc brakes when the master cylinder is mounted below or level with the calipers, to prevent fluid drain back that can cause excessive pedal travel. A 4 wheel disc brake vehicle uses two valves, one in the front circuit and one in the rear circuit. This 10lb valve is the one for drum brake circuits, which use it regardless of where the master cylinder is mounted. It is a general-fit part, so match it to your brake setup rather than to a specific vehicle.
Key features
- 10-pound valve for drum brake circuits
- -3AN male inlet fitting
- -3AN male outlet fitting
- Billet aluminum construction
- Black anodized finish
- Premium grade component
- Billet aluminum frame mounts are available separately
Before you install
A residual pressure valve sits in the brake line between the master cylinder and the wheel circuit. Its job is to hold a small amount of pressure in the lines, which helps keep fluid in place and the pedal firm when the system is at rest. Where the valve goes, and which rating applies, depends on whether the circuit feeds disc or drum brakes and where the master cylinder sits relative to the calipers.
Before ordering, check the thread and flare type on the existing lines and the fittings at the valve. A -3AN male end needs a matching female fitting, and mixing thread types with adapters adds leak points. Confirm the fitting orientation so the valve sits without strain on the hard lines.
After installation, bleed the circuit fully and check pedal feel before driving. Re-check each fitting for seepage over the following days, since a small weep at a fitting is often the first sign of a loose connection or a seal that needs replacing.
- Disc or drum circuit in your layout
- Master cylinder height relative to the calipers
- Fitting thread and flare type
- Clearance for the lines at the mounting point
- Bleeding procedure after any line work
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6805145 |
| UPC | 844165052364 |
| Pressure | 10 Pounds (10lb valve) |
| Inlet diameter | -3AN Male |
| Outlet diameter | -3AN Male |
| Material | Billet Aluminum |
| Finish | Black Anodized |
| Mounts included | No |
| Quantity | 1 |
| Grade | Premium |
| Country of origin | USA |
Vehicle fitment
It is a general-fit residual pressure valve rather than a vehicle-specific part, so fitment depends on your brake layout: master cylinder location, disc or drum circuits and fitting size. Because the valve is sold as one piece with -3AN male fittings at both ends, compare its thread size with the line you plan to connect.
Installation notes
The valve uses -3AN male threads at both ends, so confirm your lines and fittings are -3AN before installing. Mounts are not included; the billet aluminum frame mounts are sold separately. Because the valve controls residual line pressure in the brake system, have it installed by a qualified brake technician and bleed the system afterward.
What’s included
One residual valve (Quantity 1).
Not included: Billet aluminum frame mounts, which are available separately.












