Overview
The TrakMotive OE replacement rear CV axle, part number TRMPOL-7043, is a left or right rear axle for the 2014–2017 Polaris RZR XP 1000 and RZR XP 4 1000, and for the 2016–2017 RZR XP Turbo and RZR XP 4 Turbo.
The axle uses a solid chrome steel center shaft that is up to 20% stronger than OEM. It is precision machined and heat treated, comes fully assembled with its dust boots in place, and carries a one year limited warranty. Power travels from the differential to the rear wheel through this axle while the wheel moves with the suspension. The joints handle changing angles and steady rotation, and the boots keep grease in and dirt and water out.
Key features
- Solid chrome steel center shafts, up to 20% stronger than OEM
- Precision machined and heat treated
- High quality neoprene rubber dust boots
- Fully assembled, with all necessary hardware included
- One year limited warranty
Turbo and non-Turbo models
Turbo models run higher engine output, so the drivetrain sees more torque under hard acceleration. A rear axle on a Turbo machine can be a good candidate for closer inspection of joints and boots during routine service, even when the replacement is a direct OE-style part.
Non-Turbo XP 1000 and XP 4 1000 machines with a similar riding style see less load, but rough trails still work the joints hard. Rear axle life depends more on boot condition and cleaning than on the engine alone.
When ordering, match the left or right position and the model family first, then confirm the fit for your year and trim. Keep the old axle in hand for comparison during fitting.
- Match the left or right position
- Inspect boots more often on Turbo models
- Keep grease off the brake and tire areas
- Check fasteners after the first few rides
Specifications
| Brand | TrakMotive |
|---|---|
| Part number | TRMPOL-7043 |
| Position | Rear, left or right |
| Center shaft | Solid chrome steel |
| Strength | Up to 20% stronger than OEM (manufacturer rating) |
| Dust boots | High quality neoprene rubber |
| Warranty | One year limited |
Vehicle fitment
The fitment covers these Polaris models:
- RZR XP 1000: 2014–2017
- RZR XP 4 1000: 2014–2017
- RZR XP 4 Turbo: 2016–2017
- RZR XP Turbo: 2016–2017
Turbo models are covered only for 2016 and 2017, and model years 2013 and earlier or 2018 and later are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The axle needs no modifications, so it installs in the rear position using the hardware included with it. Because the fitment covers both the XP 1000 family and the Turbo models, check your model before fitting it. Match the rear left or rear right unit to the side being replaced. The rear position is where this axle goes, so confirm that the machine’s rear position matches it.
What’s included
The axle comes fully assembled with all necessary hardware, and it carries a one year limited warranty.









