Overview
The TrakMotive OE replacement CV axle, part number TRMPOL-7045, is a front axle for the left or right side of 2001–2005 Polaris Ranger 4×4 500 and Ranger 6×6 500 models.
The axles are built for rough terrain, water, mud and sand. The solid chrome steel center shaft is rated up to 20% stronger than OEM. A CV axle carries power from the differential to the wheel while letting the wheel steer and move with the suspension, so the joints and shaft handle both load and changing angles.
Key features
- Solid chrome steel center shaft
- Up to 20% stronger than OEM, per the manufacturer
- Precision machined and heat treated
- Neoprene rubber dust boots
- Fully assembled, with all necessary hardware included
Matching the machine
Ranger 500 models vary in drivetrain layout and trim, so the check goes beyond the model name. Note the body style, the front axle position and the side you need before buying. Most installs only need the correct side and the correct model name, but confirming the year removes guesswork.
Front axles on these machines take a lot of punishment in mud and water. Hard steering, rough ground and deep crossings all load the joints. Keeping the boots intact and the grease clean is the simplest way to extend the life of the shaft and joints.
If the machine has been ridden hard in water, pull the boots and check for grit before the next ride. Replace any cracked boot at the same time, since a fresh axle with a damaged boot will not stay protected.
- Confirm the side before ordering
- Check boots after deep water crossings
- Look for play in the joints
- Keep the clamps tight
Specifications
| Brand | TrakMotive |
|---|---|
| Part number | TRMPOL-7045 |
| Position | Front, left or right |
| Center shaft | Solid chrome steel |
| Strength | Up to 20% stronger than OEM (manufacturer rating) |
| Dust boots | Neoprene rubber |
| Warranty | One year limited |
Vehicle fitment
The fitment covers the 2001–2005 Polaris Ranger 4×4 500 and the 2001–2005 Polaris Ranger 6×6 500. Both body styles are listed, so either machine can be checked against this pair of entries.
Ranger 570, 900 and 1000 models are not covered, and neither are years before 2001 or after 2005. The axle fits some models in the range, so check the model name and year on your machine before installing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The axle comes fully assembled and needs no modifications for installation. It is an OE replacement for the left or right front position on these 500 models, so it installs where the original axle was, using the included hardware. Confirm which side the machine needs before starting. Confirm the axle sits in the front position on your Ranger 500 before fitting it. Match the shaft and joint layout to the part being removed.









