Overview
The RockJock RJ-151401-101 is a rear 2-inch bump stop kit for the 2020–2026 Jeep Gladiator JT. It is part of RockJock’s JT off-road suspension system and includes two fabricated steel spacers that bolt to the existing bump stop pads on the factory differential housings.
The spacers are powder coated semi-gloss black. The kit includes all necessary hardware and complete instructions. It is a rear part and a direct fit for the Gladiator trims covered under Vehicle fitment.
Key features
- 2 inch rear bump stop spacers
- Two fabricated steel spacers
- Bolts to the existing bump stop pads on the factory differential housings
- Powder coated semi-gloss black
- Hardware and complete instructions included
Rear height and spacer use
A rear bump stop spacer moves the point where the axle meets the bump stop, which changes how much compression travel is available before the stop takes load. Bump stops protect the shocks and the axle housing at the end of compression, so their position matters. Check the rear after installation to confirm that the spacers sit flat against the pads.
Rear spacers work best when the rest of the suspension is set up to match the height change. Check brake line slack, shock length and driveshaft angle, then inspect the spacer finish for chips after trail use. Powder coat can scratch during installation, so touch up exposed steel to slow surface rust.
- Check that spacers sit flat on the pads
- Inspect brake line slack after installation
- Look for rub on shocks and axle housing
- Touch up chipped coating on steel spacers
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JRJ-151401-101 |
| Position | Rear |
| Spacer material | Fabricated steel |
| Finish | Powder coated semi-gloss black |
| Lift | 2 inch rear bump stop |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2020–2026 Jeep Gladiator JT in its Launch Edition, Mojave, Overland, Rubicon, Sport and Sport S trims.
Wrangler and earlier Gladiator models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The spacers bolt to the existing bump stop pads on the factory differential housings. RockJock says complete instructions are included, and the bump stop height should be checked after the install for clearance at full compression.








