Overview
The TeraFlex SpeedBump Bumpstop Kit, part number 1958400, is a composite progressive bump stop kit for 2007–2015 Jeep Wrangler JK models. Bump stops limit how far a suspension can compress, and this kit is designed to soften the hard bottoming that can jar a Wrangler on rough trails or poorly maintained pavement.
TeraFlex builds the SpeedBump as a progressive stop, so resistance builds gradually as the suspension nears its limit instead of meeting a hard stop. That softer landing is designed to reduce impacts that stress the suspension and axle housing, and it helps the driver keep control over rough ground. It is designed for JK Wrangler applications with 3-3.5 inches of lift.
Key features
- Progressive compression, so resistance builds gradually rather than abruptly.
- Closed-cell, nitrogen-charged microcellular polyurethane body with performance tuning.
- Designed to hold its flexibility in temperature extremes, including sub-zero conditions.
- Delrin acetal resin shaft that is self-lubricating for thousands of continuous cycles.
- External shaft seal wipes and cleans the shaft to keep contaminants out of the housing.
- Maintenance free, with no custom adjustment or tuning required.
Matching stops to suspension height
Progressive bump stops only work as intended when the suspension is set up around them. A lift that changes spring height moves where the stop engages, so the stop may be doing more work than its original design. Measure travel at full droop and full compression before and after the change, and watch whether the stops contact the frame, axle or brake lines.
Composite stops are often replaced along with the shocks, because a worn shock can change how much travel is left and how the stop loads. Check the shaft and seal on each stop at regular intervals, wipe away grit, and replace any stop that shows splitting, deep cracks or a seal that no longer sits flush.
- Re-check fastener torque after the first few drives
- Inspect front spacers for cracks or wear
- Look for rub marks on the bell area after off-road use
- Keep the set matched front to front and rear to rear
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1958400 |
| UPC | 843885025122 |
| Body material | Closed-cell nitrogen-charged microcellular polyurethane |
| Shaft material | Delrin acetal resin |
| Lift range | Designed for JK applications with 3-3.5 inches of lift. |
| Included in kit | Two front and two rear SpeedBump bump stops, front adjustment spacers, front lower bump stop strike pads |
| Fitment type | Direct fit |
| Maintenance | Maintenance free |
Vehicle fitment
The manufacturer fitment list covers 2007–2015 Jeep Wrangler (JK), with trims including Rubicon, Sahara, Sport, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, the 70th Anniversary editions and the X trims.
It fits 2007–2015 Jeep Wrangler (JK) models, including Rubicon, Sahara, Sport, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, 70th Anniversary editions and X trims. Other Wrangler generations, including the TJ, LJ and 2018–2022 JL, are a different fit.
Installation notes
This is a bolt-on installation. On the front, the factory bump stop bell has to be removed first, and that removal applies to front applications only. No welding is required. The front adjustment spacers and lower strike pads are part of the front set. Because the bump stops affect suspension travel, have the install checked by a qualified technician before driving off-road.
What’s included
The kit includes two front SpeedBump bump stops, two rear SpeedBump bump stops, front adjustment spacers and front lower bump stop strike pads.









