Overview
The front 2 inch bump stop extension, part number RE1301, is a bolt-on lower axle extension for 2018 and 2019 Jeep Wrangler JL and 2020 through 2026 Jeep Gladiator models.
The extension fits inside the front coil and adds 2.0 inches of limitation for larger tires. It is a direct-fit part.
Key features
- Bolt-on installation
- 2.0 inch front lower axle bump stop extension
- Fits inside the front coil
- Adds limitation for larger tires
Bump stops and tire clearance
A bump stop limits how far the axle can travel upward before the suspension stops, protecting the shock and the coil from being overloaded. When larger tires are fitted, the tire can reach the fender or frame sooner, so limiting travel too far is a risk on the trail. A bump stop extension moves the stopping point, which changes how the suspension behaves at full compression.
Before installing one, check tire rubbing with the steering turned fully in both directions and with the suspension compressed. Worn bump stops are often cracked or flattened, so inspect the rubber pads on the old stop when you remove it. Shock mounts and coil seats are worth inspecting in the same job.
- Check fender clearance at full left and right lock
- Look for cracks or flattening in old bump stop pads
- Recheck the bolts after the first few drives
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1301 |
| Position | Front, lower axle |
| Installation | Bolt-on |
| Extension | 2.0 inches |
| Location | Inside the front coil |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2018 and 2019 Jeep Wrangler JL in two-door and four-door models, and the 2020 through 2026 Jeep Gladiator.
Wrangler JL models from 2020 onward and Wrangler JK and earlier are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The extension limits front suspension travel, so check your tire size and fender clearance after installing it.
What’s included
Front lower axle bump stop extension, part RE1301.











