Overview
The TeraFlex SpeedBump Bump Stop Kit, part number 1958602, is a set of rear composite bump stops for the Jeep Wrangler JK, designed for vehicles with a 6 inch lift. Bump stops limit how far the suspension can compress, and this kit uses a progressive design so the stop engages gradually rather than all at once. It is a direct fit for 2007–2015 Jeep Wrangler (JK) models.
The progressive design reduces harsh bottoming, and the closed-cell polyurethane body keeps its feel in heat and in sub-zero cold. Absorbing harsh impacts can help reduce the risk of axle housing bends. The kit adds 2-inch upper bump stop extensions alongside the two rear bump stops, so the full set comes in one box.
Key features
- Progressive composite bump stop that engages gradually as the rear suspension compresses
- Closed-cell nitrogen charged microcellular polyurethane body
- Designed to perform across temperature extremes, with sub-zero flexibility.
- Delrin acetal resin polymer shaft that is self-lubricating and resists wear
- External shaft seal that wipes and cleans the shaft against contaminants
- Maintenance free with no custom adjustment or tuning needed
- Bolt-on installation with no cutting or welding
- Upper bump stop extensions included for 6 inch lift applications
Lift height and bump stop setup
Bump stop height matters most when the lift changes the suspension’s geometry. A 6 inch lift moves the axle farther from the frame, so the factory stop no longer sits where it did before the lift. Extensions or a progressive stop like this one bring the contact point back into a controlled range so the axle does not reach the frame at full compression.
Before installing, check the shock lengths, brake line slack and driveshaft angles, since a lift affects all of them. After the first few trail runs, re-check the bump stop bolts and inspect the rubber body for cracks or flattened areas. Keep both rear stops matched so the axle loads evenly on each side.
- Confirm brake line and shock length after lifting
- Re-check bolts after the first few trail runs
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1958602 |
| UPC | 843885025160 |
| Position | Rear |
| Lift height | 6 inch |
| Bump stop body material | Closed-cell nitrogen charged microcellular polyurethane |
| Shaft material | Delrin acetal resin polymer |
| Upper extensions | 2-inch upper bump stop extensions |
| Sold as | Pair |
Vehicle fitment
It is a direct fit for 2007–2015 Jeep Wrangler (JK) models, including Unlimited versions and Rubicon, Sahara, Sport and X trims, along with the 70th Anniversary editions. It is designed for JK Wrangler models with a 6 inch lift. Rear bump stops for other Wrangler generations are a different part.
It does not fit the earlier TJ or LJ Wrangler or the JL generation that followed. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rear installation is bolt-on and needs no cutting or welding. Install both rear bump stops as a pair. Support the vehicle on jack stands before working under it.
What’s included
The kit includes two rear SpeedBump bump stops and 2-inch upper bump stop extensions. It is sold as a pair.









