Overview
The Rubicon Express RE1895-175 is a 17.5 inch long rear CV drive shaft for the Jeep Wrangler (TJ) Rubicon. It is a direct fit for the TJ Rubicon with an NP2421OR transfer case and works with long arm suspension systems.
It fits 2003–2006 Jeep Wrangler (TJ) Rubicon models. It works with 1801 and 1807 slip yoke eliminators, and the length is measured center to center on the U-joint with the slip stub at the center of its travel.
Key features
- Rear CV drive shaft
- 17.5 inches long
- Direct fit for TJ Rubicon with NP2421OR transfer case
- Compatible with 1801 and 1807 slip yoke eliminators
- Fits long arm systems
Driveline angles and length
The rear drive shaft transfers power from the transfer case to the axle, and its angles change as the suspension moves through its travel. Length and joint angle matter because a shaft that is too short or too long can bind, pull out of the slip yoke, or cause vibration at speed. When fitting any shaft with a slip yoke eliminator, measure the vehicle in its running position, since suspension height changes the required length.
Inspect the transfer case output and axle pinion flanges for wear before installing, and replace the U-joints or yoke seal if they are worn at the same time. Check the joint boots for tears and grease leaks during routine service, and listen for clicking or popping in turns, which can signal a worn joint. Tighten the strap bolts to the specified torque and recheck them after the first drives.
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1895-175 |
| UPC | 614901439458 |
| Length | Extended, 17.5 inches |
| Joint type | CV |
| Position | Rear |
| Transfer case | NP2421OR |
| Slip yoke eliminator | Required |
| Fitment type | Universal fit |
Vehicle fitment
It fits the 2003–2006 Jeep Wrangler (TJ) Rubicon.
The list does not include the TJ models other than the Rubicon, the Wrangler LJ or the JK. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A slip yoke eliminator is required with this shaft. Measure the vehicle on the ground in the running position to confirm the correct length before ordering.
What’s included
One rear drive shaft. Confirm the mounting parts you need before starting the installation.


