Overview
The Rubicon Express CVF Drive Shaft (part number RE1887-430) is an extended-length CV rear drive shaft for 4-door models. It has a 1310 series U-joint, is compatible with the 1801 and 1807 slip yoke eliminators, and works with the RE1805 flange adapter.
The shaft is a universal fit for the rear position, but driveshaft length has to match each vehicle. The length is set center to center on the U-joint, with the slip stub at the center of its travel.
Key features
- CV joint style driveshaft
- Extended length, not stock length
- 1310 series U-joint
- Compatible with 1801 and 1807 slip yoke eliminators
- Works with the RE1805 flange adapter
Driveshaft angles and wear
A CV driveshaft carries torque through constant-velocity joints that handle the changing angle between the transfer case and the axle as the suspension moves. Drivetrain angle matters: when the angles are unequal or the length is off, the joints work harder and vibration can build at speed. Keeping the suspension geometry in its normal range helps the shaft last.
Inspect the shaft for dents, bent tubes and loose or missing balance weights. Check the U-joint and CV boot for cracks, grease loss and play. A clicking sound on turns can point to a worn CV joint, while a vibration that rises with speed often points to an angle or balance problem.
Keep the joints greased to the specification and replace the boots if they tear. Many drivers also check the slip stub and the yoke for smooth movement during each service interval.
- Check the boot for tears and grease loss
- Listen for clicking on turns
- Look for vibration that rises with speed
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1887-430 |
| UPC | 614901439434 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| U-joint | 1310 series |
| Slip yoke eliminator required | No |
Vehicle fitment
It is a universal fit for the rear position, but it is not sized for a single vehicle. Measure your vehicle for the correct length before installing.
Confirm your vehicle’s year, model and trim before ordering. Measure your vehicle on the ground in its running position to get the correct length.
Installation notes
Measure the vehicle on the ground in the running position, center to center on the U-joint, with the slip stub at the center of its travel. Measure the length rather than assuming a stock length.
What’s included
One drive shaft. The RE1805 flange adapter is a separate part and is not included.








