Overview
The Rubicon Express RE1898-365 is a rear CVF drive shaft in extended length, made for the RE1807 and RE1801 slip yoke eliminator kits and for Currie Enterprises tail shaft conversion kits.
It is universal fit, so no single vehicle sets the length. Measure from the flange face to the center of the rear U-joint, with the slip stub at the center of its travel, using a reading taken with the vehicle on the ground in the running position.
Key features
- Rear CVF drive shaft
- Extended length
- Designed for the RE1807 and RE1801 eliminator kits
- Compatible with Currie Enterprises tail shaft conversions
- Requires a slip yoke eliminator
Tube and joint basics
An extended shaft has more tube length to balance, and balance is what keeps vibration down at speed. Tubes are usually balanced as a set with the yokes and joints in place, so a replacement should be installed in its original orientation. Mark the tube and yoke before removing the old shaft.
The joints carry the work. A rear CV joint transmits torque through changing angles, and the boot keeps the grease clean. Mud, sand and water are the main enemies, so a damaged boot is worth fixing early. Keep the flange bolts snug after the first few drives on new hardware.
Clean all mating surfaces before assembly so the flange seats evenly.
- Mark yoke and tube orientation before removal
- Replace a torn CV boot promptly
- Re-check flange bolts after the first drives
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1898-365 |
| UPC | 614901439694 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| Fitment | Universal fit |
| Slip yoke eliminator | Required |
| Measured from | Flange face to center of rear U-joint |
Vehicle fitment
It is a universal fit shaft, so pair it with the eliminator or conversion kit your build uses. Choose the kit first, then confirm the length against your driveline.
Confirm your vehicle’s year, model and trim before ordering, and make sure the length suits your driveline.


