Select your vehicle

Rubicon Express CVF Drive Shaft – RE1898-185

Rubicon Express

Shop Rubicon Express Drive Shafts on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Rubicon Express RE1898-185 CVF rear drive shaft, extended length
  • Compatible with RE1807 and RE1801 slip yoke eliminator kits
  • Also works with Currie Enterprises tail shaft conversions
  • UPC 614901439526

Description

Overview

The Rubicon Express RE1898-185 is a rear CVF drive shaft in extended length. It works with the RE1807 and RE1801 slip yoke eliminator kits and with Currie Enterprises tail shaft conversion kits.

The shaft is a universal fit, so size it to your own driveline. Measure from the flange face to the center of the rear U-joint, with the slip stub at the center of its travel and the vehicle on the ground in the running position.

Key features

  • Rear CVF drive shaft with CV joint
  • Extended length
  • RE1807 and RE1801 slip yoke eliminator compatibility
  • Currie Enterprises tail shaft conversion compatibility
  • Slip yoke eliminator required

Driveline length and angles

A driveshaft has to be the right length to allow for suspension travel without bottoming out the slip joint or stretching the joints. Length is set by the distance between the transmission or transfer case and the axle, so measure carefully before ordering and avoid guessing from another vehicle.

Angle matters as much as length. A CV joint handles more angle than a standard U-joint, but both need the correct operating angles to last. Keep angles within the limits suited to the lift height, since excessive angles wear joints quickly and cause vibration.

After installation, check for vibration at speed, binding at full droop or contact with the frame. Inspect boots, grease the joints at the intervals suited to your use, and keep the shaft balanced.

Specifications

Brand Rubicon Express
Part number RE1898-185
UPC 614901439526
Joint type CV
Length Extended
Position Rear
Fitment Universal fit
Slip yoke eliminator Required
Measured from Flange face to center of rear U-joint

Vehicle fitment

Fit depends on length, so the shaft must suit the driveline it goes into.

Confirm your vehicle’s year, model and trim before ordering, and make sure your eliminator or conversion kit is one of the compatible kits.

SKU: R/ERE1898-185 Category:

Specification

Shipping weight 17.10 lbs
Package dimensions 20.50 × 4.30 × 4.30 in
brands

Questions & Answers

Does the RE1898-185 work with a tail shaft conversion?

Yes. It works with Currie Enterprises tail shaft conversion kits. Confirm your conversion kit before ordering, and make sure a slip yoke eliminator is part of the setup.

Which slip yoke eliminator kits fit the RE1898-185?

The RE1807 and RE1801 slip yoke eliminator kits fit this shaft. A slip yoke eliminator is required, so choose one of these kits when you order the extended shaft.

Is the RE1898-185 a universal fit shaft?

Yes. It is a universal fit shaft, so no single vehicle applies. Measure your driveline from the flange face to the center of the rear U-joint before ordering.

What signs show a driveshaft needs attention?

Vibration at speed, clicking or clunking when turning, and grease leaking from a joint all point to wear or misalignment. Inspect the boots and joints regularly and address problems before they affect the axle.

Can a driveshaft be rebalanced after modification?

Often yes. A driveline shop can check balance after length or joint changes, which helps reduce vibration. Ask the shop to check balance before the shaft goes back into service.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop Rubicon Express Drive Shafts on Amazon