Overview
The Rubicon Express drive shaft package is a 2-door front and rear driveshaft set for the Jeep Wrangler and Rubicon in the JK generation. It is for 2012 to 2017 JK models with a manual transmission and for 2007 to 2011 JK models with a manual or automatic transmission.
The shafts use Dana Spicer 1310 CV style joints and are meant to replace the factory shafts after a lift. Rubicon Express recommends the package for vehicles with 3.5 inches or more of lift.
Key features
- Dana Spicer 1310 CV style front and rear shafts
- Yoke flanges for the front and rear shafts
- 1310 U-joints
- Dynamically balanced to reduce vibration
- Billet aluminum flange
- Lengths from 15.5 to 38.5 inches
Driveshaft length and lift
A driveshaft carries engine torque from the transmission to the axles, and its length and angles change when a lift raises the drivetrain. On a lifted Jeep, factory shafts can bind or vibrate once the pinion and transfer case move, which is why shafts sized for the lift are used. The joints should run at small angles, since sharp angles increase vibration and joint wear.
Before installing, check that the transfer case yoke and flange match the new shafts, and confirm the length suits your lift height. Inspect the U-joint caps for play or dry bearings at each service, and re-grease them if the joints have fittings. Dynamic balancing reduces vibration, but a bent shaft or a loose strap bolt can still cause it, so check the balance after any driveline work.
- Check that the transfer case yoke and flange match
- Confirm pinion and transfer case angles after the lift
- Replace worn U-joints when play develops
- Tighten strap bolts to specification after the first drive
Specifications
| Brand | Rubicon Express |
|---|---|
| UPC | 700007978121 |
| Joint type | 1310 CV style |
| Length range | 15.5 to 38.5 inches |
| Body style | 2-door |
| Transmission | Manual for 2012–2017; manual or automatic for 2007–2011 |
| Slip yoke eliminator | Not required |
| Fitment type | Universal fit, front and rear |
Vehicle fitment
This package is for 2-door JK Wrangler and Rubicon vehicles from 2007 to 2011 and from 2012 to 2017.
It is for 2-door models, so 4-door Wrangler Unlimited vehicles are not covered by these years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shafts are designed to run with the replacement transfer case yoke and flange from Rubicon Express. Driveshaft lengths are for factory gasoline engines.
What’s included
The package includes the front and rear drive shafts and the yoke flanges.














