Overview
The Rubicon Express HWC10075 is an Extreme Duty crossmember hardware kit for the 1997 to 2002 Jeep Wrangler TJ. It is used with Rubicon Express part numbers RE4100 and RE4102.
The kit is a direct fit for the TJ crossmember application. Check the kit contents when it arrives, before starting installation.
Key features
- Extreme Duty crossmember hardware
- Fits 1997 to 2002 Jeep Wrangler TJ models
- Used with RE4100 and RE4102
- Direct fit
Installing crossmember hardware
Crossmember hardware holds the crossmember in position under the vehicle, and it takes repeated loads from off-road use. Before installation, lay out the pieces, check each fastener against the crossmember holes and make sure the hardware matches the parts you are installing.
Clean threads and mating surfaces before assembly and apply thread lubricant only where the installation calls for it. Tighten fasteners in an even sequence so the crossmember seats square, and recheck them after the first few trail outings.
Inspect hardware on a regular schedule, especially after rough trails or heavy impacts. Look for elongated holes, bent brackets, rust or any fastener that has loosened, and replace worn pieces rather than reusing them. Keep the old hardware until the new kit is confirmed to fit, and note any differences from the original parts.
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | HWC10075 |
| UPC | 614901434859 |
| Used with | RE4100 and RE4102 |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1997 to 2002 Jeep Wrangler (TJ), including the SE, Sahara, Sport and X trims.
The list covers only the TJ, so later Wrangler generations are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The Extreme Duty crossmember hardware kit. Check the individual pieces against your crossmember installation before starting.



