Overview
The Poison Spyder BFH II Rear Crossmember (part number 17-17-010) is a replacement rear crossmember for the 2007 to 2016 Jeep Wrangler JK, in two-door and four-door models. It is cut from 3/16 inch steel plate and brake-formed to fit, and it replaces the stock rear crossmember when the frame rails are trimmed for maximum ground clearance and departure angle.
The crossmember is made to work with the Poison Spyder BFH II Rear Bumper, which fits over it like a glove. Used on its own, it works as an ultra-minimalist high-clearance rear bumper, and the dimpled lightening holes give it a finished look. This part number has no integrated hitch receiver, so it is used with the JK BFH II Rear Bumper – Tabs or the JK BFH II Rear Bumper – Tabs – Lights. A version with a hitch receiver, part 17-17-030, is sold separately.
Key features
- 3/16 inch steel plate, CNC laser cut and brake formed to fit
- Replaces the stock rear crossmember and strengthens the rear frame
- Dimpled lightening holes remove weight
- Works with the BFH II Rear Bumper or on its own
- No integrated hitch receiver on this part number
- Laser-cut steel template included to guide the frame cuts
Choosing a crossmember setup
A rear crossmember carries the rear frame and bumper loads, so replacing it is a structural job rather than a surface upgrade. Steel plate versions are heavier than the factory piece but give the rear frame a stiffer anchor point for trail use. The crossmember also sets the rear departure angle once the frame is trimmed, so the cut location matters.
Decide on the bumper and hitch arrangement before cutting anything. Pairing the crossmember with a matching bumper keeps the load paths the way the design intends. If a hitch will be needed later, weigh that now rather than adding one afterward. Bare steel needs paint or a rust-inhibiting coat soon after welding, and welded seams should be cleaned and primed before finishing.
- Mark and check cut lines before the first cut
- Grind and prime welds before painting
- Confirm rear driveline clearance after the frame cut
- Plan for spare tire and tail light wiring
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 17-17-010 |
| UPC | 614901750775 |
| Type | Rear frame crossmember, replacement |
| Material | 3/16 inch steel plate |
| Hitch receiver | None on this part number |
| Finish | Bare steel, to be painted after installation |
| Installation type | Cutting and welding required |
Vehicle fitment
It fits the 2007 to 2016 Jeep Wrangler JK in two-door and four-door models, in several trims, including the Rubicon, Sahara, Sport and Unlimited versions.
Other generations are not in the manufacturer list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting the stock frame rails and the bumper mounts, then welding the new crossmember in place. Read the installation instructions and the frame modifications before buying, since the cuts are permanent. The laser-cut steel template is provided to help make the cuts accurately. The crossmember ships bare steel and has to be painted after it is welded in.
What’s included
The 3/16 inch steel BFH II Rear Crossmember and a laser-cut steel template for the frame cuts.
Not included: the BFH II Rear Bumper, which the crossmember is designed to work with. The hitch-receiver version of the crossmember is part 17-17-030.




