Overview
The Omix-ADA 17116.56 is a heater supply hose for the 1987-1990 Jeep Wrangler (YJ) with a 4.2L 6 cylinder engine. It is a direct-fit OE replacement with Supply position.
A supply hose carries hot coolant from the engine to the heater core, starting the heater loop. The listed type is Return while the position is Supply, so confirm the routing against your old hose before fitting.
Key features
- Supply-position heater hose
- Fits 4.2L 6 cylinder engines
- Direct-fit OE replacement
- Built to original specifications.
Supply hose and heater flow
The supply hose carries hot coolant from the engine toward the heater core, so it sees the most heat in the heater loop. On a 4.2L six in a Wrangler YJ, that heat and the engine’s movement can harden the rubber near the fittings. Leaks at this end are common and usually show up as a drip under the dash or a wet spot near the firewall.
When replacing a supply hose, drain the coolant first and let the engine cool. Compare the new hose’s ends with the old one, because a small difference in fitting size or angle can cause a weeping joint. Reusing clamps is possible only if they are straight, uncorroded and still holding tension.
- Check both hose ends for cracks
- Replace worn clamps
- Refill and bleed air from the system
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17116.56 |
| UPC | 804314159597 |
| Position | Supply |
| Type | |
| Engine | 4.2L 6 cylinder |
| Fitment type | Direct Fit |
Vehicle fitment
Omix-ADA lists 17116.56 for the 1987-1990 Jeep Wrangler (YJ) in Base, Islander, Laredo, S, Sahara and Sport trims.
Use your year, model and trim to confirm this fit before ordering.
Installation notes
Check both ends and the routing against the hose you are replacing, since the listed type and position differ. Drain coolant before disconnecting the hose.
What’s included
One supply hose is described. No clamps or hardware are described.









