Overview
The Omix-ADA 17116.51 is a return heater hose for the 1987-1990 Jeep Wrangler (YJ) with a 4.2L 6 cylinder engine. It is a direct-fit OE replacement built to the original specifications.
A return line carries coolant from the heater core back toward the engine, closing the heater loop. Omix-ADA lists both the position and the type of this hose as Return.
Key features
- Return-position heater hose
- Fits 4.2L 6 cylinder engines
- Direct-fit OE replacement
- Carries a limited five-year warranty from Omix-ADA
Replacing a return hose
A return heater hose sits on the cool side of the heater loop, bringing coolant back to the engine after it passes through the heater core. When it softens, cracks or swells, the heater may run cool, the cabin may take longer to warm, or coolant may seep at the clamps. Check every heater hose at the same time, since the other lines in the loop are the same age.
Draining the cooling system is part of this job, so it is a good time to inspect the water pump, thermostat housing and radiator cap. Hoses that feel spongy or stiff when cool should be replaced rather than reused. Keep the old hose until the new one is in place so you can compare bends and end fittings.
- Look for cracks, bulges or soft spots along the length
- Check clamp ends for seepage or dried coolant residue
- Inspect the heater core fittings for corrosion
- Refill with the coolant type your engine requires
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17116.51 |
| UPC | 804314159535 |
| Position | Return |
| Type | Return |
| Engine | 4.2L 6 cylinder |
| Fitment type | Direct Fit |
Vehicle fitment
Omix-ADA lists 17116.51 for the 1987-1990 Jeep Wrangler (YJ) in Base, Islander, Laredo, S, Sahara and Sport trims.
Confirm fit for your vehicle’s year, model and trim before ordering, especially for other Wrangler generations and Cherokee models.
Installation notes
Hose swaps usually mean draining the cooling system first and checking clamp condition, so keep a drain pan close. Hot coolant can burn, so let the engine cool before disconnecting either end.
What’s included
The package contains one return heater hose. Check for clamps and other hardware against your installation before starting.









