Overview
The Omix-ADA heater motor switch, part number 17903.01, is a 2-speed control switch with 3 terminals. It is a direct OE replacement built to original specifications. It carries a limited five year warranty.
Key features
- 2-speed operation
- 3 terminals
- Direct OE replacement built to original specifications
- Limited five year warranty.
Switch wiring and checks
The heater switch selects blower speed by routing power through a set of contacts or a resistor circuit. Because the switch is a control part, a fault often appears as a fan that will not change speed, runs on only one setting, or cuts out when the dash is moved. Test continuity at each speed before assuming the blower motor has failed.
A two-speed switch is simpler than a multi-speed one, but terminal orientation still matters. Mark the wires and note their positions before removing the old switch, and take a photo of the connector. Look for melted plastic, corroded pins or loose crimps, which can cause intermittent operation.
- Label every wire before disconnecting
- Check connector pins for heat damage
- Test each speed with a meter
- Keep ground connections clean and tight
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17903.01 |
| UPC | 804314037284 |
| Speeds | 2 |
| Terminals | 3 |
| Warranty | Warranty coverage is limited to five years. |
Vehicle fitment
It is a direct fit switch for Jeep parts in general. Verify the year, model and trim of your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The heater motor switch itself, part number 17903.01.
Not included: No additional parts such as a wiring harness or mounting hardware are listed.









