Overview
The Omix-ADA 13202.31 is a 60 inch retractable lap seat belt in gray for the 1987 to 1995 Jeep Wrangler (YJ). It fits front or rear positions with a 2 point mount, and it is a direct OE replacement under part number OAI13202.31.
Omix-Ada direct OE replacement Jeep parts carry a limited five year warranty. The belt is a factory replacement.
A lap belt crosses the hips only, and a retractable belt winds in when not in use. The 13202.31 uses a 2 point mount, attaching at two anchor points, for either a front or rear position. Seat belts are safety equipment, so use only the correct anchor points and replace a belt that is worn, frayed or damaged. Compare the new belt with the old one for width, buckle type and anchor points before installing.
Key features
- 60 inch retractable lap belt
- Gray color
- Front or rear application
- 2 point mount
- Factory replacement, built to original specifications
- Carries a limited five year warranty
Seat belt replacement checks
A seat belt is a restraint system, so its condition matters more than its appearance. Check the webbing for fraying, cuts, stiffness, stains and heat damage, and make sure the buckle latches with a firm click. A retractable belt should wind back smoothly and lock when pulled quickly. Any belt that has been worn in a crash should be replaced, even if it looks sound.
Retractor and anchor hardware is often reached through trim panels, so plan the job before starting. Keep the anchor bolts clean and free of rust, and confirm that the belt routes past the seat without pinching. Replacing belts in pairs is common when both seats show the same wear.
- Check the webbing for fraying along its full length
- Test the retractor by pulling the belt out quickly
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 13202.31 (OAI13202.31) |
| UPC | 804314235666 |
| Part type | Retractable lap seat belt |
| Length | 60 inch |
| Color | Gray |
| Mount | 2 point |
| Position | Front or rear |
| Factory replacement | Yes |
| Fit type | Direct Fit |
| Warranty | Limited five year |
Vehicle fitment
The manufacturer fitment list for the Omix-ADA 13202.31 seat belt is:
- 1987 to 1995 Jeep Wrangler (YJ) (Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara, Sport)
The belt is made for the Wrangler YJ, so check your year, model and trim before ordering.
Installation notes
Seat belts are safety equipment, so professional installation is advisable. Use the correct anchor points and tighten the hardware to the torque values for your vehicle. Make sure the belt latches and retracts properly before driving, and check local regulations.









