Overview
The Omix-ADA Heater Switch, part number 17903.04, is a heater blower switch built as a direct OE replacement Jeep part to original specifications. It carries a limited five year warranty.
Confirm the application for your Jeep before ordering.
Diagnosing a heater switch
The heater blower switch controls fan speed through the climate system, so a fault shows up as a fan that will not run, runs on only one speed, or cuts out unpredictably. A switch that works only when the dash is pushed can point to a worn contact or a broken connector. Before replacing the switch, check the fuse, the blower motor and the wiring, because those can produce the same symptoms.
Replacing the switch is a dash-level job with little room to work. Disconnect the battery, label the connectors, and keep track of the screws. If the wiring harness looks brittle or melted, repair it before installing a new switch. Reconnect and test every fan speed and the air-direction controls before reassembling the trim panels.
- Check the fuse before replacing the switch
- Label connectors before removing the switch
- Test all fan speeds before closing the dash
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17903.04 |
| UPC | 804314133139 |
| Product type | Heater blower switch (HVAC heater control switch) |
| Fit type | Direct fit |
| Warranty | Limited five year warranty |
Vehicle fitment
Model and year coverage for the 17903.04 is unknown, so the application needs confirming before ordering.
Match the switch to your Jeep’s year, model and trim before installing.
Installation notes
Heater switches sit behind the dash, so torque the hardware to the values in a service manual for your Jeep.
- Hold the old switch next to the new one to confirm they match.
- Recheck the connections after the first few drives.
- Hand it off to a professional if removing the dash panels is unfamiliar territory.









