Overview
The Motive Gear GM12-411 is a 4.11 ratio replacement ring and pinion for GM 12 Bolt truck rear axles in the 8.875 Inch size. It is the final drive gear pair that sets how many driveshaft turns happen per wheel turn.
The gears are 8620 steel and went through CNC work and computer controlled heat treatment. Motive Gear places the set in its light duty O.E. quality replacement range, for everyday trucks and for on and off road use.
Key features
- 4.11 ratio for the 8.875 Inch GM 12 Bolt axle
- 8620 steel gear construction
- CNC processing throughout
- Computer controlled heat treatment
- Built to light duty O.E. quality standards for everyday trucks, for on and off road use.
On the trail
Off road driving puts extra load on the rear axle, and the ring and pinion carries that load through the final drive. A ratio that suits the tires and the terrain can make low speed work easier, but it also changes engine speed at highway speed. Consider how the truck is used most of the time before choosing a gear set for a GM 12 Bolt axle.
Gear swaps often pair with a check of the carrier and the axle bearings, since those parts are under the same load. If the truck has a limited slip or locker, its clutch packs or lock parts should be inspected at the same time. Watch for noise and heat after the first trail runs and recheck the gear setup if anything changes.
- Match the ratio to tire size and terrain
- Inspect carrier and axle bearings
- Check any limited slip or locker parts
- Recheck gear noise after trail runs
Specifications
| Brand | Motive Gear |
|---|---|
| Part number | GM12-411 |
| UPC | 698231020517 |
| Gear ratio | 4.11 |
| Axle type | GM 12 Bolt 8.875 Inches |
| Axle location | Rear |
| Axle manufacturer | GM |
| Material | 8620 steel |
| Duty | Light duty |
Vehicle fitment
No vehicle is named for this set. It is for GM 12 Bolt truck rear axles in the 8.875 Inch size with a 4.11 ratio. Confirm your vehicle’s year, model and trim before ordering.
Ford and Chrysler axles are different parts and are not covered by this GM listing.
Installation notes
A shop typically sets pinion depth and backlash on a GM 12 Bolt gear swap. Expect a break-in period and a speedometer recheck after a ratio change.
What’s included
The ring and pinion pair is the only item included.
Not included: Carrier bearings, pinion bearings and shims are not included, so check your rebuild needs before ordering.











