Overview
The King Shocks 25001-374 is a rear piggyback reservoir shock absorber for the 2018 Jeep Wrangler JL, covering 2-door and 4-door models. It is a gas charged 2.5 Piggyback Reservoir shock for stock height and for lifts in the 0 to 2.5 inch range.
The valving was developed for JL models to maximize performance and comfort. The zinc plated cylinders measure 2.5 inch outside diameter, and the 7/8 inch hard chromed shafts run through a hard anodized finned reservoir in a piggyback layout. The shock is bolt-on for stock and lifted trucks alike.
Key features
- Piggyback reservoir layout on the rear axle
- 100% bolt-on installation for stock and lifted applications
- Large zinc plated 2.5 inch outside diameter cylinders
- Hard anodized aluminum finned reservoir
- 7/8 inch diameter hard chromed shafts
- Valving specific to 18+ JL models
- Gas charged.
- Fully rebuildable and serviceable
Choosing a JL rear shock
Rear shocks on a Jeep JL carry the axle through daily driving, trail crossings and the weight of gear. A piggyback reservoir separates the fluid and gas chamber from the shock body, which gives more room for oil and helps the shock shed heat on longer runs. When comparing rear shocks, look at the reservoir layout, the cylinder diameter, the shaft size and the mounting style, because each affects how the shock fits and how it feels.
Replace rear shocks in pairs and check the rear bushings and mounts at the same time. Inspect the reservoir hose for chafing, since a rubbing hose can wear through near the frame or the driveline. After the first few trail runs, recheck the mounting bolts and look for oil on the cylinder or the reservoir body, which can signal a worn seal.
Specifications
| Brand | King Shocks |
|---|---|
| Part number | 25001-374 |
| UPC | 700008516741 |
| Shock series | 2.5 Piggyback Reservoir |
| Charge | Gas charged |
| Position | Rear |
| Lift range | 0 to 2.5 inch |
| Cylinder outside diameter | 2.5 inch, zinc plated |
| Shaft diameter | 7/8 inch, hard chromed |
| Reservoir | Hard anodized aluminum, finned |
Vehicle fitment
It is a rear shock for the 2018 Jeep Wrangler JL in Rubicon, Sport, Sport S, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport and Unlimited Sport S trims. It does not fit JK or TJ Wranglers.
The front shock is a separate part number, 25001-373. Check the year, model and trim against your Jeep before ordering.
Installation notes
The shock is bolt-on, so the stock rear mounting points are reused. Replace rear shocks in pairs so ride and damping stay balanced from side to side. Route the reservoir hose, if fitted, so it stays clear of the driveline.
What’s included
Confirm the quantity in the box when the parts arrive, and check the mounting hardware against your installation before starting.
Not included: The front shock, 25001-373, is a separate part number.









