Overview
The G2 Axle and Gear 35-2033B is a front Dana 44 master ring and pinion kit with a big bearing set. The Ford applications are 1994–1996 F-150 and Bronco front axles. 1991–2001 Dodge 1500 front axles are not a confirmed fit for this kit, so confirm fit before ordering.
It is a master kit with bearings, so it covers the full ring and pinion job. The bearings are Timken inner and outer pinion bearings with races and carrier bearings with races. The kit also includes a pinion nut, pinion seal, crush sleeve, pinion and carrier shims, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Key features
- Master kit with big bearings
- Timken inner and outer pinion bearings with races
- Carrier bearings and races
- Crush sleeve, pinion nut and pinion seal
- Pinion and carrier shims, ring gear bolts and sealant
Bearing set and preload
A big bearing master kit is aimed at heavier use, where stock bearings may be too small for the load. The races and bearings are installed fresh with the gear set, so the front carrier starts from a clean setup. Bearing preload and carrier shims need careful setting, because too much or too little preload shortens bearing life quickly.
Front Dana 44 jobs often happen with the axle out of the vehicle or on a stand, so a clear plan helps. Pack the bearings with fresh grease, use a torque wrench on the pinion nut, and confirm the carrier bearing caps are seated correctly. Replace the pinion seal during the job, since leaks are hard to fix once the axle is back together.
- Use a torque wrench on the pinion nut
- Check the pinion seal before reassembly
- Check gear oil level after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2033B |
| UPC | 631410095838 |
| Axle location | Front |
| Axle type | Dana 44 |
| Kit type | Master kit with bearings, big bearing |
| Bearings | Timken pinion inner and outer, carrier bearings and races |
Vehicle fitment
It fits 1994–1996 Ford F-150 and Bronco front axles.
1991–2001 Dodge 1500 front axles are not a confirmed fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This master kit includes the bearings, so the front carrier is set up with new races and bearings. Use the gear marking compound to check tooth contact while setting the shims, and note that gear set setup is precise work.
What’s included
Timken outer and inner pinion bearings with races, carrier bearings and races, a pinion nut and seal, a crush sleeve, pinion and carrier shims, ring gear bolts, and the compounds and sealer.










