Overview
The G2 Axle and Gear 35-2044A is a master ring and pinion install kit for a Toyota 9.5 inch LC axle with an open differential. The contents cover Timken pinion bearings and races, shims, carrier bearings and races, and the compounds used in a gear install.
No model years are named for this kit. Confirm the axle size and differential type before installing.
Key features
- Timken inner and outer pinion bearings with races
- Pinion and carrier shims for gear setup
- Carrier bearings and races included
- Ring gear bolts, thread locking compound and silicone sealer
- Gear marking compound for tooth contact checks
Gear setup on a 9.5 inch
An open differential sends torque to both wheels, and when one wheel loses grip the other can stop turning. For a gear change, that means the carrier needs consistent preload on both sides and the ring gear must run true. Check the carrier for runout before installing the ring gear, since a bent carrier will give noise under load.
Pinion depth, carrier preload and backlash are the settings that decide how the new gears run. Gear marking compound confirms tooth contact, and the pattern should be checked before the axle is fully assembled. Tighten the pinion nut with the crush sleeve in place, and recheck preload after the axle has been run for a short time.
- Check carrier runout before the ring gear goes on
- Confirm tooth contact before final assembly
- Use fresh thread locker on ring gear bolts
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2044A |
| UPC | 631410128864 |
| Axle manufacturer | Toyota |
| Axle size | 9.5 inch |
| Model reference | LC |
| Differential | Open differential |
Vehicle fitment
The kit is for a Toyota 9.5 inch LC axle, but no model years are named. Check your axle size and differential type before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, carrier preload and backlash are the critical settings on a 9.5 inch swap. Use gear marking compound to confirm the tooth pattern before the axle is fully assembled. A professional gear setup and break-in is the safer route for new gears.
What’s included
The kit includes a pinion nut, pinion seal, Timken outer and inner pinion bearings with races, crush sleeve, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound and silicone sealer.
Not included: A ring and pinion gear set is not among the contents.






