Overview
The Toyota 9.5 inch minor ring and pinion install kit, part number 25-2063, is a set of installation parts for fitting a ring and pinion gear set. The kit is for the Toyota 9.5 inch axle.
Key features
- Pinion nut and pinion seal
- Crush sleeve
- Pinion shims and carrier shims
- Ring gear bolts
- Thread locking compound and gear marking compound
- Silicone sealer
Choosing the right setup
Ring and pinion installs depend on accurate shimming, so the first step is confirming the axle size and the gear set you plan to fit. Pinion and carrier shims work together to set mesh and backlash, and the crush sleeve sets bearing preload. Each of these parts is adjusted by measurement during the job rather than being swapped by guess.
Because the kit does not include gears, the gear set should be inspected before the install begins. Look for chipped teeth, pitting and uneven wear on both ring and pinion. Keep the housing clean, use the sealer where the cover closes, and refill with fresh gear oil when the work is finished.
- Confirm axle size before buying
- Inspect the gear set for wear
- Measure shims rather than guessing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2063 |
| UPC | 631410129250 |
| Application | Toyota 9.5 inch axle |
| Product type | Ring and pinion installation kit |
Vehicle fitment
The kit is for the Toyota 9.5 inch axle.
Confirm the axle size against your vehicle before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring and pinion work requires correct gear setup, shimming and measurement, so professional installation is a good choice. Set the gear mesh and pinion preload carefully, and tighten fasteners to the values appropriate for the gears being installed.
What’s included
- Pinion nut
- Pinion seal
- Crush sleeve
- Pinion shims
- Carrier shims
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included: the ring and pinion gear set itself; no gears are listed in this kit.






