Overview
The Curt Manufacturing CRT56127 is a battery-powered 4-flat wiring T-connector for the 2011–2018 Mitsubishi Outlander Sport. It is made for towing wiring and plugs directly into the factory harness. It is designed for setups with an LED tail light only.
Key features
- Plugs directly into the factory harness
- Battery powered
- 4-flat wiring T-connector
- Designed for LED tail light setups only
- Listed install time of 45 minutes
Before you buy
A T-connector gives a trailer wiring circuit a tap point in the vehicle’s rear lighting harness, so trailer lights can be wired without cutting factory wiring. The connector only carries signals the harness already sends, so it helps to settle the trailer’s lighting needs first. Check whether the tail lights are LED units, since that changes how the trailer side draws current and how the lights respond.
After installation, check the connections during the first few stops of a trip. A loose ground point often causes flicker or dim lights, so re-check the screw after the first drives. Battery-powered units also need attention. Look at the battery condition before a long tow and replace it when it begins to fade, because a weak battery can make the signal unreliable.
- Confirm the tail light type before choosing a setup
- Clean the ground point to bare metal
- Check the battery before long trips
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT56127 |
| Connector style | 4-flat |
| Power | Battery powered |
| Lighting | LED tail light only |
| Install time | 45 min |
| Included | 4-pin connector, dust cap, ground wire with self-tapping screw |
Vehicle fitment
It fits the 2011–2018 Mitsubishi Outlander Sport in ES, GT, LE, SE and SEL trims.
The list does not include the standard Mitsubishi Outlander. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The connector plugs into the factory harness, and the ground wire is secured with the included self-tapping screw. Curt lists 45 minutes for the install.
What’s included
A 4-pin connector, a dust cap and a ground wire with a self-tapping screw.









