Overview
This Crown Automotive 52000849 is the driver side wheel cylinder for 1993 to 1996 Jeep Grand Cherokee ZJ models. Its job is to convert hydraulic pressure from the brake line into outward movement of the brake shoes against the drum.
Key features
- Driver side position
- Grand Cherokee ZJ application, 1993 to 1996
- Crown Automotive replacement cylinder
- Part number 52000849 with UPC 848399012507
Wheel cylinder service tips
A wheel cylinder sits behind the drum brake shoes and pushes them outward when pressure travels through the brake line. Because it is close to the drum, it is exposed to brake dust, road water and heat, so the boot and body can wear over time. Leaks often appear as fluid on the inside of the drum or on the backing plate, and a soft pedal can follow.
When a cylinder is replaced, the brake shoes, drums and hydraulic lines are commonly inspected at the same time, since worn shoes or a damaged line can undo the new part’s work. Keep the master cylinder reservoir topped up during the job and never let it run dry, because that pulls air back into the system and makes bleeding harder.
- Inspect the backing plate for fluid before fitting
- Bleed the system until the fluid runs clear of bubbles
- Use fresh brake fluid from a sealed container
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52000849 |
| UPC | 848399012507 |
| Position | Driver side |
| Vehicle | 1993 to 1996 Jeep Grand Cherokee (ZJ) |
| Part type | Wheel cylinder |
Vehicle fitment
It fits 1993 to 1996 Jeep Grand Cherokee ZJ models on the driver side.
The listed years are narrower than the ZJ production run, and the later WJ Grand Cherokee (1999-2004) is not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
After fitting the new cylinder, bleed the hydraulic brake system to remove trapped air before driving.
What’s included
One driver side wheel cylinder is described. Not included: Brake shoes and hard lines are not included.
















