Overview
The Crown Automotive J4200095 is a Dana 30 spindle nut sold as nut only, with no washer or other hardware.
Crown Automotive presents it as a replacement part for Jeep vehicles. No vehicle years or models are named for this nut, so the Dana 30 spindle is the only fitment detail given.
Key features
- Nut only
- Made for the Dana 30 spindle
- Direct fit for the Dana 30 spindle
- Crown Automotive replacement part, item J4200095
Before you install a spindle nut
Spindle nuts hold the wheel bearing and hub on the axle spindle, so the nut sets how the bearing is preloaded. Before installing one, look at the threads on the spindle and the bearing surface for rust, galling or damage. Clean both surfaces so the nut seats evenly and gives a consistent reading when torqued.
A worn or stretched spindle nut can back off over time, which lets the hub move and wears the bearing early. Replace the nut if the threads are damaged or if it no longer seats squarely. Torque it to the value in your axle service manual, then recheck it after the first few drives.
- Inspect spindle threads for damage before use
- Confirm the washer already on the spindle is the correct type
- Recheck the nut after the first short drives
Specifications
| Brand | Crown Automotive |
|---|---|
| UPC | 848399062311 |
| Axle | Dana 30 |
| Contents | Nut only |
Vehicle fitment
It is made for the Dana 30 spindle. Confirm the spindle type on your axle and your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One spindle nut.
Not included: Washers and other hardware are not part of this item.









