Overview
The Crown Automotive 68048466AA is a front axle nut for the 2007–2018 Jeep Wrangler (JK), in 2-door and 4-door models. It fits either the driver or passenger side front axle shaft and works with Dana 30 or Dana 44 front axles.
The axle nut is the large nut that retains the front axle shaft and hub assembly on the knuckle. Because the same nut serves both front axle types and both sides, one part number covers every front shaft on the Wrangler (JK), though each side needs its own nut.
It is a direct fit for the Wrangler (JK) front axle.
Match the nut by part number 68048466AA before ordering.
Key features
- Front axle nut
- Fits Dana 30 or Dana 44 front axles
- Driver or passenger side front axle shaft
- 2-door and 4-door models
- Direct fit for the Wrangler (JK) front axle.
- Fits the 2007–2018 Jeep Wrangler (JK)
Front axle nut care
The axle nut holds the front shaft and hub assembly in place, so it carries a lot of load and depends on its threads and any locking feature. Before installing a nut, inspect the shaft threads for damage, clean debris from the hub, and confirm the nut sits square against its seat. A nut that is cocked or galled will not clamp evenly, which can lead to looseness and noise at the hub.
Front axles see off-road loads that can work a nut loose over time, so check the hub area on a regular schedule, especially after deep water, rock impacts or heavy use. Reusing a nut is a judgment call. Replace it if the threads are stretched or the locking feature no longer holds. Tighten to the Jeep service procedure using a calibrated torque wrench, and complete any locking step before the hub goes back into service.
- Inspect shaft threads before installing a new nut
- Clean the seat so the nut sits square
- Recheck the hub area after deep water or rock strikes
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68048466AA |
| UPC | 848399087567 |
| _pn | 68048466AA |
| Part type | Axle nut |
| Position | Front |
| Axles | Dana 30 or Dana 44 front |
| Side | Driver or passenger |
| Body styles | 2 and 4-door models |
| Fit type | Direct fit (Crown) |
Tightening torque follows the Jeep service procedure.
Vehicle fitment
It covers the Jeep Wrangler (JK) from 2007 through 2018, including Unlimited versions. Because the nut is specific to the front axle, fit applies to the whole model and years rather than particular trims.
The manufacturer fitment list for part 68048466AA covers: 2007–2018 Jeep Wrangler (JK).
Not listed: the Wrangler (JL), earlier Wranglers such as the TJ and YJ, and any rear axle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The nut belongs on the front axle shaft, so the hub assembly has to be accessible. Follow the Jeep service procedure for the tightening torque and for any lock or staking feature, since Crown gives no figures.
What’s included
- One front axle nut, 68048466AA









