Overview
Baer Brakes part number 6920868 is a right-side, 1-piece full cast replacement brake rotor with a 14-inch outside diameter and a slotted, drilled and zinc-plated surface. It is a service part for the ES+1 and AlumaSport Baer brake setups.
The rotor uses a 6-stud pattern on a 5.50 inch bolt circle and has a 3.095 inch center hole, the register that centers the rotor on the hub. It is directional, meaning it is built for the right side of the vehicle only, and it is made from cast iron with a vented design.
Key features
- Directional rotor built for the right side only
- 1-piece full cast construction
- Slotted, drilled and zinc-plated surface
- Curved vane design that Baer describes as optimum cooling
- Dynamically balanced for vibration-free performance
- Vented cast iron rotor
Hub match and rotor side
A full cast one-piece rotor is cast as a single casting, so the hat and friction ring are not separate parts. This simplifies mounting but means the whole rotor is replaced if the friction surface wears beyond its limit. Before buying, measure the existing hub face and compare the center hole and bolt circle, since a mismatch can cause vibration that is hard to trace.
Slotted and drilled surfaces help clear gas and debris, but they also create edges that wear over time. Inspect the slots and drilled holes for cracks around the openings during routine service. Pads should be matched to the rotor and the Baer caliper in use, and worn pads should be replaced before they cause scoring on the friction face.
- Measure the hub face before buying
- Check the drilled holes for cracks
- Use matched pads for the caliper
- Mount the rotor with clean, bare hub surfaces
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920868 |
| UPC | 844165037279 |
| Axle position | Right |
| Outside diameter | 14 inch |
| Nominal thickness | 1.15 inch |
| Overall height | 2.309 inch |
| Center hole diameter | 3.095 inch |
| Bolt hole circle diameter | 5.5 inch |
| Bolt hole quantity | 6 |
| Construction | Full cast, one piece |
| Surface type | Slotted, drilled and zinc plated |
| Material | Cast iron |
| Rotor style | Vented |
| Brake surface | Directional |
| Drum in hat | No |
| ABS tone ring included | No |
| Country of origin | CN |
Vehicle fitment
It is tied to the ES+1 and AlumaSport systems, so the correct match depends on your Baer caliper and hub setup.
Before buying, match your vehicle’s year, model and trim to an ES+1 or AlumaSport setup.
Installation notes
Verify the right-side marking before mounting, because a left-side rotor is a separate part. Match the 5.50 inch bolt circle, 6-stud pattern and 3.095 inch center hole to your Baer hub before fitting. Test the brakes at low speed after installation, and keep speeds low until they feel normal.
What’s included
One right-side replacement rotor.
Not included: the ABS tone ring and a left-side rotor.












