Overview
The Baer Brakes 54050-020 is a set of front performance brake rotors for the 1997-1999 Ford Expedition, the 1999 Ford F-150 Lightning and the 1999 Lincoln Navigator in 2WD (rear-wheel-drive) configuration. Each rotor is a one-piece, full cast, vented cast iron disc with a cross-drilled and slotted friction surface, designed as a direct replacement for the factory front rotor.
The slots and drilled holes let gases and dust escape from between the pad and rotor during braking, which supports a more consistent pedal feel and less brake fade. The zinc-plated finish keeps the rotor face bright behind open-center wheels, and each rotor is mill balanced. This set matches the 2WD Ford and Lincoln applications covered below.
Key features
- Cross-drilled and slotted friction surface that vents gases and dust away from the pad face
- Enhanced vane structure, which Baer describes as improving cooling and durability
- Chamfered cross-drilled holes, intended to reduce stress cracking
- Zinc-plated finish for open-center wheels
- Mill balanced, direct replacement design with an ABS tone ring included
- Directional brake surface with a 5-stud mounting pattern
Before you install
Front rotors are a brake safety part, so fit and condition should be confirmed before the wheels go back on. Start by cleaning the hub face and checking for rust or burrs that could cause runout. Mount the rotor flat against the hub so it sits without rocking, then check the lug threads and wheel studs for damage.
Rotors often get replaced with new pads, and a worn caliper or seized slide pin can damage a fresh rotor quickly. Inspect the calipers and brake hoses during the job, and bleed the system if the pedal feels soft afterward. Keep old rotors out of service once they fall below the discard thickness, and test the brakes at low speed in an open area before normal driving.
- Clean the hub face before mounting
- Check the rotor for runout after installation
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 54050-020 |
| UPC | 844165000617 |
| Axle | Front |
| Drive | 2WD |
| Rotor type | Vented, one-piece, full cast |
| Material | Cast iron |
| Surface type | Slotted and cross-drilled |
| Brake surface | Directional |
| Disc finish | Zinc plated |
| Stud/lug hole quantity | 5 |
| Mounting bolt hole circle diameter | 135 |
| Outside diameter | 308.1 |
| Overall height | 102.6 |
| Discard thickness | 27.9 |
| Stud size | 12mm studs |
| ABS tone ring included | Yes |
| Emission code | 6 |
| Grade type | Premium |
| Country of origin | CN |
Vehicle fitment
The manufacturer fitment list names these front-rotor applications:
- 1997–1999 Ford Expedition, RWD (through 11/99)
- 1999 Ford F-150 Lightning (through 11/99)
- 1999 Lincoln Navigator, RWD (through 11/99)
The list does not include 2000 and later Expedition, F-150 or Navigator models, the 1999 F-150 models other than the Lightning, or any other Ford or Lincoln model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The set specifies 12mm studs and a 5-stud pattern on a 135 bolt hole circle, so check your hub against these figures before fitting. An ABS tone ring is included, so confirm it is supplied with your rotors when you open the box. Brakes are safety-critical, so have the work checked by a qualified technician if you are unsure.
What’s included
A pair of front rotors sold as a set, with ABS tone ring included.
Not included: Brake pads and caliper hardware are not included.














