Overview
The Baer Brakes 6920165 is a right-side, 1-piece tall hat replacement brake rotor with a 12 inch outside diameter, 0.81 inch nominal thickness and a slotted finish. It is used in select Baer brake systems and is sold as one rotor.
This is a full cast, one-piece vented rotor rather than a two-piece design. It has a curved vane design for cooling, dynamic balancing for vibration-free performance and a stability design intended to resist distortion. Compare the 5 x 4.75 inch stud and lug pattern and the 2.78 inch center hole against the hub.
Key features
- Right-side rotor with a directional brake surface
- One-piece full cast construction with a tall hat
- Slotted surface on a vented cast iron rotor
- Curved vane design for optimum cooling
- Dynamic balanced for vibration free performance
- Stability design intended to resist distortion
Choosing a rotor for the hub
Full cast, one-piece rotors are a single casting with the hat built in, which keeps the hat and braking surface as one part. That design can simplify alignment compared with two-piece units, but the entire rotor is replaced when the friction surface wears. Measure the existing rotor’s overall height and center hole before ordering, because a mismatch in hat height can move the braking surface out of line with the caliper.
Slotted surfaces help shed water and brake dust, which suits hard use or wet conditions, but they add pad wear over time. Replace pads together with the rotor and bed them in with a few moderate stops. Inspect the wheel studs for damage, and clean rust off the hub face so the rotor sits flat.
- Compare hat height and center hole with the original
- Clean the hub face and studs
- Check the directional mark before fitting
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920165 |
| UPC | 90127961803 |
| Axle | Right |
| Construction | Full cast, one piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Slotted |
| Outside diameter | 12 in |
| Nominal thickness | 0.81 in |
| Overall height | 2.224 in |
| Center hole diameter | 2.78 in |
| Stud/lug hole circle diameter | 4.75 in |
| Stud/lug hole quantity | 5 |
| Drum in hat | No |
| Material | Cast iron |
| Grade type | Performance |
| ABS tone ring included | No |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It is used in select Baer brake systems. Confirm your vehicle’s year, model and trim before ordering, and compare the hub measurements before use.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rotor is directional and sold individually, so this right-side unit belongs on the right axle only. Check the 5 x 4.75 inch pattern, 2.78 inch center hole and 2.224 inch overall height against the hub before fitting. A mismatched hub can cause runout or vibration, so have a qualified technician set up the assembly.
What’s included
One right-side, one-piece tall hat replacement brake rotor.
Not included: ABS tone ring.
