Overview
The Baer Brakes 54071-020 is a set of two front Claw performance rotors for the 2000–2002 Ford Excursion built from 11/99, the 1999–2002 Ford F-250 Super Duty 2WD with four-wheel ABS, and the 1999–2002 Ford F-350 Super Duty 2WD with single rear wheels. They are direct replacement vented rotors with a slotted and cross-drilled friction surface.
Slots and drilled holes let gases and dust move out from between pad and rotor, supporting a more consistent pedal and reduced brake fade. Each rotor is one-piece full cast iron with a zinc-plated finish. Each rotor includes an ABS tone ring and measures 330.96 outside diameter, with an eight-stud, 170 bolt circle pattern.
Key features
- Slotted and cross-drilled friction face that Baer says vents gases and dust
- Enhanced vane structure that Baer describes for cooling and durability
- Mill balanced direct replacement rotor
- Chamfered cross-drilled holes that Baer says reduce stress cracking
- ABS tone ring included with the rotor
ABS tone rings and wear
An ABS tone ring works with the wheel speed sensor to tell the brake module how fast each wheel turns. When a tone ring is damaged or loose, the ABS or traction light may come on. Check the sensor gap and the tone ring teeth when the hub is apart, and clean any rust or debris from the mating surface.
Trucks used for towing or hauling put heavy loads on the front brakes, so pads and rotors wear faster than in light use. Stopping performance also depends on tire condition and load. Replace front rotors in pairs so both sides wear and stop evenly.
- Check the wheel speed sensor wiring for chafing
- Clean the hub mounting face before fitting the rotor
- Replace pads with rotors when either is near its limit
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 54071-020 |
| UPC | 844165045731 |
| Sold as | Set (two rotors) |
| Axle | Front |
| Drive | 2WD |
| Rotor type | Vented |
| Construction | One-piece, full cast |
| Material | Cast iron |
| Surface type | Slotted and cross-drilled |
| Brake surface | Directional |
| Disc finish | Zinc plated |
| Grade type | Premium |
| Outside diameter | 330.96 |
| Overall height | 143.5 |
| Discard thickness | 36.1 |
| Mounting bolt hole circle diameter | 170 |
| Stud/lug hole quantity | 8 |
| ABS tone ring included | Yes |
| Emission code | 6 |
| Country of origin | CN |
Vehicle fitment
It fits the 2000–2002 Ford Excursion built from 11/99, the 1999–2002 Ford F-250 Super Duty and the 1999–2002 Ford F-350 Super Duty, all in 2WD configurations.
The list does not cover 4WD versions of these trucks or any Super Duty model from 2003 onward. The F-350 entry applies to single rear wheel trucks. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brake surface is directional, so check the rotation marking on each rotor and fit the pair to match. Because the ABS tone ring is included, confirm it sits correctly against the hub before the wheel goes back on. Test the brake pedal at low speed before normal driving.
What’s included
The set contains two front rotors with ABS tone rings, sold as a pair.
Not included: brake pads, which are separate parts.














