Overview
The Baer Brakes 6911112 is a left-side, tall hat replacement brake rotor measuring 13.000 Inch by 1.100 Inch, with five 5.00 Inch bolt-circle studs and a 3.055 Inch register. It is a 1-piece, slotted, drilled and zinc-plated rotor for certain Baer Track4, SS4 and other Baer Brake systems, so confirm the Baer system it is built for before fitting.
The casting is made from premium materials and uses a curved vane design for cooling. The rotor is dynamically balanced, made of cast iron, and graded as performance. Its brake surface is directional, so it installs on the left side only. It is not a drum-in-hat design.
Key features
- Tall hat design
- Full cast, one-piece construction in cast iron
- Slotted, drilled and zinc-plated braking surface
- Curved vane design for optimum cooling
- Directional brake surface for the left side
- Dynamic balanced for vibration-free performance
- Vented rotor type with five studs
Choosing the right setup
Tall hat rotors raise the braking surface away from the hub, so the hat height changes how the rotor sits against the caliper and wheel. Before buying one, compare the hub’s mounting face and hat height with the rotor’s dimensions, and confirm the caliper bracket and wheel offset have room for the extra height.
Pairs should be installed as a matched set on opposite sides, with directional rotors fitted by their marked orientation. Replace pads with the rotors so the friction material seats to the new surface, and avoid mixing old and new pads on one axle because braking balance can shift.
- Confirm the hub mounting face before ordering
- Check caliper clearance over the rotor hat
- Use fresh hub bolts when the old ones are worn
- Keep brake fluid and lines in good condition
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6911112 |
| UPC | 844165054436 |
| Outside diameter | 13.000 Inch |
| Nominal thickness | 1.100 Inch |
| Overall height | 2.232 |
| Stud/lug hole circle | 5.00 Inch |
| Stud/lug hole quantity | 5 |
| Register (center hole diameter) | 3.055 Inch |
| Axle | Left |
| Material | Cast iron |
| Construction | Full cast, one piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface finish | Slotted, drilled and zinc plated |
| Drum in hat | No |
| ABS tone ring included | No |
| Grade type | Performance |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It is built for certain Baer Track4, SS4 and other Baer Brake systems rather than specific vehicles. Match your vehicle’s year, model and trim to the Baer system before buying.
Track4 and SS4 are Baer system names rather than vehicle models, so match the rotor to your Baer kit first. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rotors are sold individually and are directional, so a pair needs one left and one right unit. Fit this left unit to the left side only. Bed in new pads gradually after installation, as a new rotor surface requires.
What’s included
One left-side tall hat rotor, sold as Each.
Not included: Pads, calipers, hubs and hardware are not included with this rotor.
