Overview
The Baer Brakes Big Claw 2261030 is a front disc brake rotor set for 2004-2008 Ford F-150 4WD trucks in the new body style. The kit gives you a pair of oversized rotors and a pair of caliper relocation brackets, which move the calipers outward so the larger rotors clear while the OE pads and hardware keep fitting.
Baer built the Big Claw for owners who want more braking force from the same wheel-side layout. The company reports up to a 49 percent gain in braking effectiveness from independent testing, and it credits the larger diameter and curved vanes for lower rotor temperatures in hard use.
Key features
- Oversized rotors that add brake torque and leverage for improved stopping power
- Cross-drilled and slotted friction surface to vent dust and gases
- One-piece, full cast rotor with directional vanes that Baer describes as acting like a centrifugal pump
- OE-style brackets that reposition the caliper for the larger rotors
- Direct bolt-on system with no brake bleeding
- Zinc-plated finish that resists rust and corrosion
Keeping 4WD front brakes healthy
On four-wheel drive trucks the front brakes do a large share of the work when descending grades or towing, so the rotors are often the first part to show heat wear. Inspect the rotor face for blue discoloration, scoring or a lip at the outer edge, which signal overheating or worn pads. Measure thickness at several points around the rotor if you have a micrometer, since uneven wear causes pulsation.
Oversized rotors also change caliper position, which affects pad contact and wheel clearance. Hub bearings, the ABS sensor and the tone ring should be checked whenever the rotor is off, because they sit close to the braking parts. Clean the hub face and remove rust before fitting new rotors, and torque lug nuts in a crisscross pattern.
- Check the hub face for rust before fitting
- Inspect the ABS sensor and wheel speed wiring
- Replace pads that are worn unevenly
- Recheck lug nut torque after the first drive
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 2261030 |
| UPC | 844165004431 |
| Package | Set |
| Axle | Front |
| Drive | 4WD |
| Construction | One piece, full cast |
| Material | Cast iron |
| Rotor type | Vented, conventional, floating |
| Surface | Slotted and drilled, directional |
| Vane design | Curved |
| Finish | Zinc plated, rust resistant coating |
| Outside diameter | 15 |
| Nominal thickness | 1.181 |
| Discard thickness | 1.102 |
| Overall height | 2.126 |
| Center hole diameter | 3.547 |
| Mounting bolt hole circle diameter | 5.31 |
| Mounting bolt hole diameter | 0.625 |
| Mounting bolt holes | 6 |
| ABS tone ring included | No |
| Grade | Performance |
| Warranty | Limited 1 Year Warranty |
| Country of origin | US |
Vehicle fitment
The kit fits the front position of the 2004-2008 Ford F-150 with 4WD drive.
Not covered: 2WD F-150 trucks, and 2009 and newer F-150 models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Expect a straight bolt-on job with no brake fluid bleeding. Compare the template with every wheel you plan to run, including the spare, before mounting the rotors, since fit can vary by wheel.
What’s included
A pair of oversized rotors and a pair of new caliper relocation brackets.















