Overview
The Baer Brakes Big Claw 2261029 is a front disc brake rotor set for 2004-2008 Ford F-150 2WD trucks in the new body style. The set includes oversized rotors, caliper relocation brackets, an ABS tone ring, bearings and races, so it covers more of the front brake assembly than a rotor-only swap.
Baer aims the Big Claw at drivers who want improved braking without a full replacement system. Baer reports up to a 49 percent gain in braking effectiveness from its testing, along with lower rotor temperatures in extreme conditions, which it attributes to the curved vane design.
Key features
- Oversized rotors for greater brake torque and leverage on the front axle
- Slotted and drilled friction surface to help vent dust and gases for a consistent pedal feel
- One-piece cast rotor with directional vanes that move air for cooling and reduced fade
- OE-style caliper relocation brackets that keep OE pad and hardware compatibility
- Bolt-on system with no brake bleeding required
- Zinc-plated finish with a rust resistant coating
Hub parts and bearing service
Bearings, races and an ABS tone ring turn this job from a rotor swap into a hub-level service. Before fitting, clean the spindle and check the old bearing races for pitting, discoloration or heat marks. Bearings should turn smoothly without play, and grease should be fresh and suited to the bearing type. Mixing new bearings with worn races can shorten bearing life and cause noise.
The tone ring feeds wheel speed data to the ABS system, so it must sit square and seat fully against the hub. A damaged or misaligned tone ring can set an ABS warning light. On 2WD trucks the front axle carries much of the steering and braking load, so tighten hub fasteners to the vehicle’s specification and recheck them after the first few miles.
- Clean the spindle before pressing parts on
- Check races for pitting and heat marks
- Confirm the tone ring seats square against the hub
- Use fresh grease suited to the bearing type
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 2261029 |
| UPC | 844165004448 |
| Package | Set |
| Axle | Front |
| Drive | 2WD |
| Material | Cast iron |
| Rotor type | Vented, conventional, floating |
| Surface | Slotted and drilled, directional |
| Vane design | Curved |
| Finish | Zinc plated, rust resistant coating |
| Outside diameter | 15 |
| Nominal thickness | 1.181 |
| Discard thickness | 1.102 |
| Overall height | 2.126 |
| Center hole diameter | 3.547 |
| Mounting bolt hole circle diameter | 5.31 |
| Mounting bolt hole diameter | 0.625 |
| Mounting bolt holes | 6 |
| ABS tone ring included | Yes |
| Bearings included | Yes |
| Races included | Yes |
| Grade | Performance |
| Warranty | Limited 1 Year Warranty |
| Country of origin | US |
Vehicle fitment
The kit fits the front position of the 2004-2008 Ford F-150 with 2WD drive.
Not covered: 4WD F-150 trucks, and 2009 and newer F-150 models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bearings, races and ABS tone ring are included, so match each piece against your existing hub parts before fitting the set. The system is bolt-on with no brake bleeding, and the template should be compared with every wheel you plan to run, including the spare.
What’s included
A pair of oversized rotors, a pair of new caliper relocation brackets, bearings and races, and an ABS tone ring.















