Overview
The ARB BP5190002R is the front right BP-51 internal bypass shock from ARB 4×4 Accessories, made for the 2010–2014 Toyota FJ Cruiser (Base). It is a direct fit and gas charged, and it is the right-hand partner to the left unit in the same range.
The BP-51 range was built in-house by Old Man Emu ride engineers. Each shock is vehicle specific and uses the existing mounting locations, so fitting needs no extra vehicle modification. The adjustable design gives on-vehicle tuning of both rebound and compression.
ARB positions the adjustability as a step beyond compression-only adjustable shocks. Owners can tune the ride for the vehicle or for a particular trip, which is the practical reason to choose this version over a fixed-valve shock.
Several 6061 grade aluminum parts make up the unit: the remote oil canister, the spring seat, the adjuster and the top hat. The body is 51mm bore aluminum with a hard anodized type III finish, and the coil is a high quality X5K grade steel spring. Oversized rubber bushings, large Teflon lined spherical bearings and a Dash -6 high temperature Teflon hose complete the mounting and plumbing. The impact resistant shaft guard is high density polyethylene, and the hard chromed piston shaft is ground. Part number BP5190002R and UPC 9332018035837 identify the unit.
Key features
- Internal bypass design
- Independent rebound and compression adjustment
- 6061 grade aluminum remote oil canister
- Dash -6 high temperature Teflon hose
- Large, Teflon-lined spherical bearings
- Hard chromed, ground piston shaft
- Quality oversized rubber bushings
- 51mm bore with a type III hard anodized aluminum body
Pairs, positions and routine checks
Front shocks work as a pair, and a new unit next to a worn one can change how the front end responds in corners and on rough ground. Replacing both sides of an axle keeps damping balanced left to right. Because left and right units carry different part numbers, confirm the position before ordering so the set is complete.
Adjustable damping gives room to tune a unit after it is fitted, but a shock that has been overloaded or run hot may need servicing rather than adjustment. Watch for oil on the body, a bouncy front end, or uneven front tire wear, which can point to lost damping.
Routine checks should include the remote canister mount, the hose routing near moving parts, and the spherical bearings at the ends of the shock. Look for rubbing on the shaft guard and loose hardware after the first few trail runs. Keeping the mounts tight helps the shock hold its position under load.
- Confirm left and right positions before ordering
- Check hose routing near moving parts
- Inspect the shaft guard for rubbing
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | BP5190002R |
| UPC | 9332018035837 |
| Position | Front right |
| Lift height | w/0 in. lift/drop |
| Bore | 51mm |
| Shock type | Gas charged |
| Fitment type | Direct fit |
Vehicle fitment
It is made for the 2010–2014 Toyota FJ Cruiser (Base). It is not made for other FJ Cruiser years or other Toyota models.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.








