Overview
The Russell Performance 695920 is a street legal brake line assembly with braided stainless steel hoses and zinc-plated hose ends. It is a direct bolt-on kit for lifted vehicles, and its hoses are designed to meet DOT MVSS-106 requirements for street driven vehicles.
The kit fits vehicles with disc front brakes and drum rear brakes. It covers lifted applications from 2 to 4 inches, including a 4 inch lift.
Key features
- Braided stainless steel hoses
- Zinc-plated hose ends
- Factory assembled for easier installation
- Three lines per kit: two front hoses and one rear hose
- Direct bolt-on with hardware and fittings included
- Russell states DOT MVSS-106 compliance for street driven vehicles
Inspecting brake lines over time
Brake hoses flex every time the suspension moves, and on a lifted vehicle they often travel a longer path to the caliper. Over time the rubber or braided sleeve can chafe against frame edges, suspension arms or tire clearance points. Routing matters: keep hoses clear of moving parts and heat sources, and leave enough slack for full suspension travel without pulling on the fittings. Braided stainless sleeves resist abrasion better than plain rubber, but they still need a visual check.
During routine service, look at each hose end for seepage, cracked sleeves and crimp damage, and check that fittings are snug without being overtightened. A soft pedal or spongy feel after a hose change usually points to trapped air, so bleed the system thoroughly. Brake fluid absorbs moisture over time, so keep the reservoir sealed and replace the fluid on your vehicle’s service schedule.
- Look for fluid seepage at every fitting
- Keep hoses clear of springs and sway bar links
- Recheck clearance after any suspension change
Specifications
| Brand | Russell Performance |
|---|---|
| Part number | 695920 |
| UPC | 87133959207 |
| Lines per kit | 3 (two front, one rear) |
| Hose material | Braided stainless steel |
| Hose ends | Zinc-plated |
| Lift application | 2 to 4 inches (lifted) |
| Brake type | Disc front, drum rear |
| Standard | DOT MVSS-106 for street driven vehicles |
Vehicle fitment
The kit’s vehicle details are a lifted range, disc front and drum rear brakes, with no model years.
Vehicles at stock height or with other brake layouts are not covered by the stated details. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that the two front hoses and one rear hose match your disc front and drum rear setup before installing. The kit includes the hardware and fittings needed for a direct bolt-on installation. Bleed the brakes after the hoses are replaced to clear air from the lines.
What’s included
Two front hoses, one rear hose, and the hardware and fittings needed for installation.








