Overview
The Pro Comp PR2085 is a PRO-M monotube rear shock absorber for the 2007–2018 Jeep Wrangler JK, in both 2-door and Unlimited 4-door models. It is designed for JK models with a 2-inch lift and is meant for a mix of trail driving and daily road use.
The monotube body uses an internal floating piston to keep the oil apart from the nitrogen gas charge, which helps prevent the performance loss caused by cavitation. Multi-stage valving is tuned for this application, and the 2.0-inch shock body holds extra oil to help it shed heat on long off-road runs.
The shock is built with a 14mm chrome hardened shaft and a silver powder-coated body, and it comes with a polyurethane shock boot. The wiper seal has been redesigned, which Pro Comp presents as the main reason the shock is less likely to leak than earlier designs.
Key features
- Monotube body with an internal floating piston
- Multi-stage disc pack valving tuned for the application
- 2.0-inch shock body with increased oil capacity
- Redesigned wiper seal
- 14mm chrome hardened shaft
- Silver powder-coated finish
- Polyurethane shock boot included
Choosing a rear shock setup
A rear shock controls how the axle moves over bumps and under braking, so its length and damping need to match the suspension height it works with. On a Wrangler JK, the shock is only one part of the rear end. Springs, bump stops and control arms all change the travel the shock sees, which is why matching the shock to the lift matters more than matching the brand name.
Monotube designs like this one keep the oil and gas in a single body and are often chosen for steadier damping on rough trails. Pairing a new shock with fresh bushings and a boot in good condition helps the setup hold its alignment and keeps dirt out of the seal. Shocks are usually replaced in pairs so both sides damp the same way.
- Compare shock length with your installed suspension
- Inspect bushings and mounts at the same time
- Replace shocks in pairs for even handling
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | PR2085 |
| Shock series | PRO-M |
| Shock type | Monotube, nitrogen gas charged |
| Position | Rear |
| Extended length | 25 in |
| Collapsed length | 15.9 in |
| Shock body diameter | 2.0 in |
| Shaft | 14mm chrome hardened |
| Upper mount | Loop |
| Lower mount | Loop |
| Finish | Silver powder coat |
| Lift height | Models with a 2-inch lift |
| Boot | Polyurethane, included |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler JK models in both 2-door and Unlimited 4-door form, across the Sport, Sahara, Rubicon, X and anniversary editions of those years.
It does not cover the JL generation Wrangler (2018 and later), earlier TJ or LJ Wranglers, or the Gladiator. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 25-inch extended and 15.9-inch collapsed lengths are matched to a 2-inch lift. A different lift height changes the travel the shock has to cover, so compare both measurements with your suspension before installation and check clearance at full droop and at full compression.
What’s included
A single rear shock with its polyurethane boot. Check the package contents against your installation before starting.









