Overview
The Pro Comp Suspension PR2023 is a PRO-M rear monotube shock for the 2004 to 2014 Ford F-150, with 0 to 2 inches of lift. It has an extended length of 28.9 inches and a collapsed length of 18.2 inches.
The shock is nitrogen gas charged, with a floating piston and vehicle specific multi-stage valving. Pro Comp describes its body as providing extra oil capacity for heat dissipation, along with a wiper seal design it says is meant to prevent leaks.
Key features
- Rear monotube design for 0 to 2 inches of lift
- Extended length 28.9 inches, collapsed length 18.2 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- Wiper seal design
- Polyurethane shock boot included
Loaded trucks and rear shock wear
A rear shock on an F-150 handles extra weight from the bed, passengers and tow loads, so its damping works harder than a front shock. Compare the extended and collapsed lengths with the shock being removed before ordering, since a longer unit can change the rear ride height. Check that the body clears the leaf springs, frame and any hitch or bumper at full compression, because loaded trucks compress further than empty ones.
Wear shows up as oil on the body, a rear end that keeps bouncing after a dip, or a knock over washboard roads. Loop mounts and bushings should be checked at each service, since worn mounts can misalign a new shock and shorten its life. Inspect the boot as well, because grit that gets past it can scratch the shaft and damage the seal.
- Check the leaf spring clearance at full compression
- Inspect loop mounts and bushings
- Keep the shaft free of grit
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2023 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 28.9 in |
| Collapsed length | 18.2 in |
| Upper and lower mount | Loop |
| Lift | 0 to 2 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2004 to 2014 Ford F-150, in several trims including XL, XLT, STX, FX2, FX4, Lariat, King Ranch, Platinum and the 60th Anniversary Edition.
It is made for the 2004 to 2014 F-150. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The 28.9 inch extended and 18.2 inch collapsed lengths are the figures to compare with the rear shock being removed, since a longer unit can change rear ride height. Loop mounts at both ends should line up with the factory rear brackets. Because the rear shock carries a heavier load on a loaded truck, check the mounting hardware and the boot after the first few miles.
Measure the rear height before fitting, since the 0 to 2 inch lift range is the one this rear shock is designed for. Confirm the loop mounts line up with the factory brackets and that the body has clearance from the frame and the leaf springs at full compression.
Confirm the rear shock clears the leaf springs, the frame and any bumper or hitch mounted to the truck at full compression.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2023.









