Overview
The Pro Comp Suspension PR2065 is a PRO-M rear monotube shock for Jeep Wranglers with 0 to 1.5 inches of lift. It has an extended length of 19.7 inches and a collapsed length of 13.1 inches, and it fits the 1997 to 2006 Wrangler TJ and the 2004 to 2006 Wrangler LJ.
The shock is nitrogen gas charged and uses a floating piston to separate oil from the gas. Pro Comp describes its valving as vehicle specific and its wiper seal as designed to prevent leaks.
Key features
- Rear monotube design for 0 to 1.5 inches of lift
- Extended length 19.7 inches, collapsed length 13.1 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Shock length and low lift
A 0 to 1.5 inch lift leaves a Wrangler close to stock height, so the rear shock works within a narrow range. A shock that is too long can bind at full droop, and a short one can run out of travel on uneven trails. Measure the current rear height and confirm the shock suits that range before buying.
Stock-height Wranglers still see wear from trail use, and the rear shock is often the first part to show it. Look for oil, dents and a tired boot. The bump stops and mounts are worth checking too, since a worn bushing can make a new shock feel loose.
- Confirm height is within the lift range
- Check boot and mounts at each service
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2065 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 19.7 in |
| Collapsed length | 13.1 in |
| Upper and lower mount | Loop |
| Lift | 0 to 1.5 in |
| Finish | Silver powder coat |
Vehicle fitment
Coverage includes the 2004 to 2006 Wrangler LJ in Unlimited and Unlimited Rubicon, and the 1997 to 2006 Wrangler TJ in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X.
It covers TJ and LJ Wranglers only, not the JK or JL. Before ordering, check that the year, model and trim suit your Wrangler.
Installation notes
Compare the 19.7 inch extended and 13.1 inch collapsed lengths with the rear shock being removed, because a shorter unit changes the rear ride height. The 0 to 1.5 inch lift range is the one listed, so measure the height before ordering. Check the mounts against the factory brackets and make sure the shock clears the axle at full compression.
Confirm the 0 to 1.5 inch lift on your Wrangler before ordering, since the shock’s length is set for that range. Check the loop mounts for fit and confirm the body clears the frame and axle at full compression.
Check that the rear shock clears the frame and the leaf springs at full droop, and confirm the mounts are seated in the factory brackets.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2065.









