Overview
The Pro Comp Suspension PR2060 is a PRO-M front monotube shock for Jeep Wranglers with 0 to 1.5 inches of lift. It has a 21 inch extended length and a 13.7 inch collapsed length, and it fits the 1997 to 2006 Wrangler TJ and the 2004 to 2006 Wrangler LJ.
The monotube body is nitrogen gas charged. A floating piston keeps the oil apart from the gas, and the valving is set for this application.
Key features
- Front monotube design for 0 to 1.5 inches of lift
- Extended length 21 inches, collapsed length 13.7 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Keeping a short-lift setup balanced
A shock designed for a small lift works within a narrow band of travel, so the difference between a stock and a slightly raised Wrangler matters more than it might seem. Compressing the shock beyond its range can strike the internal stop or put strain on the mounts. Checking the spring height and the front axle position before buying keeps the damper working inside its design window.
The TJ and LJ suspensions are simple, and many owners replace the front shocks alongside bushings and bump stops when they refresh the front end. Look for fluid on the shaft, a hollow feel over bumps, or squeaks at the loop mounts as signs the damper is tired. Aftermarket upgrades like a higher lift or heavier tires change the forces on the shock, so reassess the setup whenever those parts change.
- Confirm the spring height before buying
- Inspect loop bushings for wear
- Look for fluid on the shaft
- Reassess after any tire or lift change
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2060 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 21 in |
| Collapsed length | 13.7 in |
| Upper and lower mount | Loop |
| Lift | 0 to 1.5 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2004 to 2006 Jeep Wrangler (LJ), including the Unlimited and Unlimited Rubicon, and the 1997 to 2006 Jeep Wrangler (TJ), including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X models.
Compare your Wrangler’s year, model and trim with these details, including any JK or JL applications.
Installation notes
This shock is designed for 0 to 1.5 inches of lift, so a Wrangler with more lift needs a longer shock. Compare the 21 inch extended and 13.7 inch collapsed lengths with the shock being removed. The loop mounts at both ends should line up with the factory brackets, and the polyurethane boot should seat fully before the shock is loaded.
This shock is intended for a lift of up to 1.5 inches, so a Wrangler with a higher lift needs a shock with a longer length. Check the loop mounts against the factory brackets and confirm the shock has clearance from the frame and the axle through full compression.
Confirm the rear shock body clears the frame and the rear axle when the suspension is at full droop.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2060.









