Overview
The Pro Comp PRO-X 929510B twin tube shock, part number EXP929510B, has a 29.8-inch extended length and a 17.1-inch collapsed length. It fits the Ford F-150 and F-250 pickups by generation, and the 1997–2003 Jeep Wrangler (TJ).
The shock has a stem top mount. Its PRO-X design uses 10-stage velocity sensitive valving, a 2.0-inch body, a 1-3/8-inch nylon banded piston and a 5/8-inch chrome hardened shaft. The 10-stage valving adapts damping to a range of road conditions while supporting handling. The shock suits paved roads with occasional off-road use. It is nitrogen stabilized with a black powder coat finish. Shock boots are sold separately, and the shock is sold individually. Ford and Jeep fitment varies by generation, so confirm the year before ordering.
Key features
- Stem top mount
- 10-stage velocity sensitive valving
- Nitrogen stabilized
- 1-3/8-inch nylon banded piston
- 5/8-inch chrome hardened shaft
- Black powder coat finish
Choosing a replacement shock
A twin tube shock uses an inner working cylinder inside an outer tube that also holds fluid, and the piston moves through that cylinder to control how fast the suspension compresses and rebounds. On a pickup, that damping shapes how the front end settles after a bump and how the rear stays composed under a load. Replacing a worn shock restores that control, and a new unit is usually most noticeable on washboard roads and during quick direction changes.
Shocks are usually replaced in pairs on the same axle so both sides damp the same way. Before choosing a length, measure the old shock’s installed length at full extension and full compression, since mounts and bump stops set the real working range. Mounting hardware, bushings and the stem or eyelet ends should be checked at the same time. Worn bushings can cause noise that gets mistaken for a bad shock.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXP929510B |
| Shock series | PRO-X |
| Shock type | Twin tube |
| Extended length | 29.8 in |
| Collapsed length | 17.1 in |
| Travel length | 12.45 in |
| Body diameter | 2.0 in |
| Upper mount | Stem |
| Gas | Nitrogen stabilized |
| Piston | 1-3/8 in nylon banded |
| Shaft | 5/8 in chrome hardened |
| Finish | Black powder coat |
| Boot | Optional, sold separately |
Vehicle fitment
It fits the 1997–2003 Ford F-150 (including Harley-Davidson Edition, King Ranch, Lariat, XL and XLT), the 1999–2003 Ford F-150 Lightning, the 1995–1999 Ford F-250, the 1997 Ford F-250 HD, the 1999–2003 Ford F-250 Super Duty and the 1997–2003 Jeep Wrangler (TJ).
The F-150 fit covers 1997–2003 only, so later generations are not covered, and the Wrangler fit is limited to the TJ. Check the year, model and trim against your vehicle before ordering.
Installation notes
Measure your current shock’s installed length before ordering, because the 29.8-inch extended and 17.1-inch collapsed lengths set the fit.
What’s included
One shock absorber, sold individually.
Not included: The shock boot, which is optional and sold separately.









