Overview
The Pro Comp Suspension PR2034 is a PRO-M rear monotube shock for Chevrolet Silverado and GMC Sierra pickups from 1999 to 2016, with 0 to 2 inches of lift. It is sold individually and has an extended length of 26.1 inches.
The shock body is nitrogen gas charged. The floating piston and multi-stage valving work together to control damping, and the 2 inch body holds more oil to aid heat dissipation.
Key features
- Rear monotube design for 0 to 2 inches of lift
- Extended length 26.1 inches, collapsed length 16.6 inches
- 2 inch diameter body
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- Polyurethane shock boot included
Setting ride height on a Silverado
Rear ride height on a Silverado or Sierra pickup depends on the springs and the shock length working together. A shock that is too long or too short can change how the rear sits under load and how the suspension moves over rough ground. Before choosing a replacement, measure the current height at the rear wheels so the new unit matches the existing setup.
Spare tire carriers and aftermarket bumpers can limit shock clearance at full compression, so look at the area around the shock body during the first test drive. Old shocks often leak oil or show a dented body. A floaty ride or a rear that bounces after bumps usually means the shocks and bushings need a look.
- Measure rear height before buying
- Test the shock by hand before fitting
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2034 |
| Shock series | PRO-M |
| Position | Rear |
| Body diameter | 2 in |
| Extended length | 26.1 in |
| Collapsed length | 16.6 in |
| Lift | 0 to 2 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2003 to 2016 Chevrolet Silverado 1500, the 1999 to 2016 GMC Sierra 1500, and the 2001 to 2006 Silverado and Sierra 2500 HD and 3500 models, along with several Classic and HD versions in between.
Check the year, model and trim of your Silverado or Sierra before ordering, especially for 2017 and later trucks and 2007 to 2010 Sierra 3500 HD models.
Installation notes
Compare the 26.1 inch extended and 16.6 inch collapsed lengths with the rear shock being replaced, since the length sets rear ride height on a Silverado or Sierra. The 2 inch body needs clearance from the rear spring and the frame at full compression. Loop mounts should line up with the factory brackets, and the boot should seat fully on the shaft before the truck is loaded.
Confirm the rear shock has clearance from the spare tire carrier, if one is fitted, and from the frame at full compression. The 0 to 2 inch lift range is the one listed, so check the height before the shock is used on rough terrain.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2034.









