Overview
The Pro Comp Suspension PR2109 is a PRO-M front monotube shock for the 2009 to 2013 Ford F-150, with 0 to 2 inches of lift. It has an extended length of 21.9 inches and a collapsed length of 16.9 inches.
The shock is nitrogen gas charged and includes a floating piston that keeps the oil separate from the gas charge. The valving is multi-stage and vehicle specific.
Key features
- Front monotube design for 0 to 2 inches of lift
- Extended length 21.9 inches, collapsed length 16.9 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Ride height and mount alignment
The front shock sets part of the truck’s ride height, so its length affects how the front sits and how the steering geometry lines up. A stem top that seats well in the upper bracket and a lower mount that lines up with the axle keep the shock working in its intended path. Mounts that are bent or worn should be replaced before the new shock goes in.
Front shocks on a pickup take a lot of load over rough roads and off-road use, so inspect the stem bushing and the boot at each oil change or tire rotation. Heat builds in the body on long descents, and a shock that feels hot or slow to return after a hard run may be worn. Replacing the shock with its partner on the other side helps the truck track evenly.
- Check the upper bracket for cracks
- Inspect the stem bushing for wear
- Look for oil or dirt around the boot
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2109 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 21.9 in |
| Collapsed length | 16.9 in |
| Lift | 0 to 2 in |
| Shaft | 14 mm chrome hardened |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2009 to 2013 Ford F-150, in trims including XL, XLT, Lariat, King Ranch, Platinum and Limited.
Check your vehicle’s year, model and trim against the fit before buying.
Installation notes
The 21.9 inch extended and 16.9 inch compressed lengths should be compared with the front shock on the F-150 before ordering, since they set the ride height at the front. The stem top mount needs to seat in the factory upper bracket, and the lower mount should line up with the axle. Confirm the boot is intact and that the shock clears the frame at full compression.
Because this front shock is built for 0 to 2 inches of lift, measure the front height before fitting. Confirm the stem top seats in the factory upper bracket and that the lower mount lines up with the axle. Check the shock body for clearance from the frame at full compression and inspect the boot after the first drive.
Confirm the shock clears the steering linkage, the brake lines and the front spring through the full range of steering.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2109.









