Overview
The Pro Comp Suspension EXPPR2088 is a PRO-M front monotube shock for Jeep Wranglers with a 3 inch lift. It fits the 1997 to 2006 Wrangler TJ and the 2004 to 2006 Wrangler LJ, and it is sold individually.
The shock is nitrogen gas charged, and its floating piston keeps oil and gas apart. The vehicle specific valving balances ride and handling.
Key features
- Front monotube design for a 3 inch lifted Wrangler
- Extended length 24 inches, collapsed length 15.2 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Choosing a lift height
A monotube shock places the piston in a single body with a separate floating piston, which keeps the gas charge and the oil apart during long trail sessions. On a lifted Wrangler, the shock controls how the axle moves over uneven ground, so its length and mounting points have to suit the height of the lift. Before buying any shock for a lifted Jeep, measure the ride height on both sides and compare it with the suspension the truck already runs.
Shocks are usually replaced in pairs on the same axle, since a new unit with different valving or length will change how the truck settles. Replacing the springs, bump stops or control arm bushings at the same time helps the whole setup work together. Look for oil residue on the body, a clunking sound over bumps, or a bouncy ride that keeps going after a dip as signs the old unit is worn.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2088 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 24 in |
| Collapsed length | 15.2 in |
| Upper and lower mount | Loop |
| Shaft | 14 mm chrome hardened |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2004 to 2006 Jeep Wrangler (LJ), including the Unlimited and Unlimited Rubicon, and the 1997 to 2006 Jeep Wrangler (TJ), including the 65th Anniversary, Rubicon, SE, Sahara, Sport and X models.
Fit for JK or JL Wrangler models is not covered here, so confirm your year, model and trim before ordering.
Installation notes
The 3 inch lift this shock is designed for should match your Wrangler before ordering, since the 24 inch extended and 15.2 inch collapsed lengths are set for that height. Compare these figures with the shock being removed. The loop mounts at both ends should line up with the factory brackets, and the shock should be checked for clearance from the frame and the axle at full compression.
Because the TJ and LJ use a loop mount at each end, check the mounts before fitting the shock and confirm the bolts are not bottomed out. Look for clearance between the shock body and the frame rail at full compression and inspect the boot for proper seating.
Check that the shock body sits square between the mounts and does not contact the spring perch or the crossmember at full extension.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2088.









