Overview
The Pro Comp 917500B is a PRO-X twin tube shock absorber for Chevrolet and GMC S-series trucks and SUVs from 1983 to 2004. It covers the Chevrolet S10 and Blazer and the GMC S15, Jimmy and Sonoma. It has a 17.55-inch extended length, an 11.05-inch collapsed length and 6.50 inches of travel.
The PRO-X is a general-purpose twin tube design for light trucks and SUVs used mostly on pavement with occasional off-road trips. It uses 10-stage velocity sensitive valving and a 5/8-inch chrome hardened shaft, which Pro Comp says helps the shock handle demanding conditions while keeping a comfortable highway ride.
Both mounts are loop eyes, and the 2.0-inch body is finished in black powder coat. The shock is nitrogen stabilized with a 1-3/8-inch nylon banded piston, and the shock boot is an optional extra that comes separately.
Key features
- Twin tube design for general-purpose use
- 10-stage velocity sensitive valving
- 1-3/8-inch nylon banded piston
- 5/8-inch chrome hardened shaft
- Nitrogen stabilized
- Black powder-coated finish
Compact truck suspension basics
S-series trucks and compact SUVs are light, so their shocks handle a different load range than full-size trucks. Over the years the most common failures are leaking seals, worn eye bushings and corroded mounts, especially where salt is used on the roads. A twin tube shock with 10-stage velocity sensitive valving is designed to keep damping smooth across both smooth pavement and short bumps.
Because these vehicles often carry older bushings and mounting hardware, the shock is rarely the only part showing wear. Sway bar end links, bump stops and the rubber isolators at the eyes are often replaced at the same time. If the old shock has been on the truck for a long time, check the axle and frame brackets for bends or cracks before fitting the new one.
- Replace worn eye bushings along with the shock
- Inspect bump stops for cracks or compression set
- Check end links and sway bar bushings for play
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 917500B |
| Shock series | PRO-X |
| Shock type | Twin tube, gas charged (nitrogen stabilized) |
| Location | Universal |
| Extended length | 17.55 in |
| Collapsed length | 11.05 in |
| Travel length | 6.50 in |
| Body diameter | 2.0 in |
| Piston | 1-3/8 in nylon banded |
| Shaft | 5/8 in chrome hardened |
| Upper mount | Loop |
| Lower mount | Loop |
| Finish | Black powder coat |
| Boot | Optional, not included |
Vehicle fitment
The shock fits the 1987–2004 Chevrolet Blazer in several trims, the 1983–2004 Chevrolet S10 in the Base, Baja, Durango, LS, SS, Sport and Tahoe trims, and the 1983–1994 Chevrolet S10 Blazer. For GMC it fits the 1983–2001 Jimmy, the 1983–1990 S15, the 1983–1991 S15 Jimmy and the 1991–2004 Sonoma.
Blazer and S-10 models from before 1983, and model years after 2004, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The fitment covers compact S-series trucks and SUVs across a long span of years, so check the loop eyes and the 17.55-inch extended length against the installed suspension before fitting, and confirm the axle or frame bracket matches the loop size.
What’s included
One twin tube shock with loop eyes at both ends. The optional boot is not included.
Not included: the optional boot and any brackets your vehicle needs.









