Overview
The Pro Comp Suspension PR2028 is a PRO-M rear monotube shock for the Ram 1500, with 0 to 2.7 inches of lift. It fits the 2009 to 2010 Dodge Ram 1500 and the 2016 to 2026 Ram 1500, and it is sold individually.
The shock body is nitrogen gas charged and uses a floating piston to separate oil from the gas. The extra oil capacity helps dissipate heat during off-road use.
Key features
- Rear monotube design for 0 to 2.7 inches of lift
- Extended length 26.4 inches, collapsed length 16.9 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Rear shock service life
A rear shock controls body movement over bumps and keeps the tires in contact with the ground under load. On a half-ton pickup it works with the leaf or coil springs and the bump stops, so a worn unit often shows up as bouncing after dips, nose-dive under braking, or a rear end that wallows on washboard. Oil leaking down the shaft, a damaged boot, or a bent eyelet are common signs that the shock needs replacing.
When a shock is replaced, the other rear shock should be replaced at the same time so both sides damp the same way. Inspect the mounting bushings and bracket welds while the old unit is off, since a worn bushing can make a new shock feel loose. Keep the boot clean and check it after off-road runs, because grit trapped against the shaft wears seals quickly.
- Look for oil streaks along the shaft
- Check the boot for tears after trail use
- Replace worn rubber bushings at the same time
- Re-torque mount bolts after the first drive
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2028 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 26.4 in |
| Collapsed length | 16.9 in |
| Lift | 0 to 2.7 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2009 to 2010 Dodge Ram 1500 in Laramie, SLT, ST and Sport trims, and the 2016 to 2026 Ram 1500 in several trims including Big Horn, Express, Laramie, Limited, Rebel and TRX.
It does not fit the 2011 to 2015 Ram 1500, the Ram 2500 or the Ram 3500. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The 26.4 inch extended and 16.9 inch collapsed lengths should be compared with the rear shock being replaced before the Ram is loaded or raised. The 0 to 2.7 inch lift range is the one listed, so measure the height first. Loop mounts need to line up with the factory brackets, and the 2 inch body should be checked for clearance against the rear spring.
Measure the truck’s rear ride height before fitting, since the 0 to 2.7 inch lift range is the one listed. Confirm the loop mounts are seated and the body clears the rear spring at full compression, then recheck the rear travel after the first drive.
Check the rear shock clears the frame and the spring perch at full droop and full compression, and confirm the mounts are seated fully.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2028.









