Overview
The Power Stop K1233-36 is a front Heavy Duty Truck and Tow brake kit for the 1995–2002 Toyota 4Runner and the 1995–2004 Toyota Tacoma. It combines slotted and cross-drilled rotors with Z36 high-friction metallic pads and has no calipers.
The K1233-36 is built for heavy-duty braking on wet, hot or hilly roads and for towing at maximum weight. Its slotted and cross-drilled rotors are coated, and it uses Z36 high-friction metallic pads instead of ceramic. Calipers and brake lines are not included, so the existing calipers stay on the truck. It is a direct fit for the front axle of 4Runner and Tacoma models from the years shown. Drilled holes and slots help the friction face shed heat, gas and water. Confirm the model year before choosing between similar Z36 numbers.
Key features
- Front kit for older 4Runner and Tacoma models.
- Slotted and cross-drilled rotors, coated.
- Z36 high-friction metallic pads.
- Power Stop pitches the Z36 line at towing and heavy loads.
- Calipers and brake lines are left out.
Towing and heavy-duty pads
Metallic pads handle heat and sustained load better than ceramic compounds, which is why they are common on trucks that tow. The trade-off is more noise, more brake dust and somewhat faster rotor wear. Coated rotors help resist surface rust between uses, but they do not change the friction behavior of the pad. Expect the first stops after installation to feel different until the pads are fully bedded.
Heavy use puts extra heat into the brake fluid, so check its condition and consider a fluid change on a regular schedule if the truck tows often. Inspect the rotor surface at every pad change for heat cracks, deep grooves or a lipped edge. Keep the existing calipers in good order, checking the slide pins and boots, since a sticking caliper can overheat one side of the truck. Replace worn hardware while the wheels are off.
Specifications
| Brand | Power Stop |
|---|---|
| Part number | K1233-36 |
| UPC | 792088564382 |
| Product type | Heavy duty truck and tow brake kit without calipers |
| Brake position | Front |
| Rotor type | Slotted and cross drilled, coated |
| Brake pads | Z36 high-friction metallic pads |
| Brake lines | Not included |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1995–2002 Toyota 4Runner and the 1995–2004 Toyota Tacoma, in the trims below.
- 1995–2002 Toyota 4Runner (Base, Limited, SR5)
- 1995–2004 Toyota Tacoma (Base, Limited, Pre Runner, SR5)
The 4Runner fits through 2002 and the Tacoma through 2004. Check your vehicle’s year, model and trim against these years before buying.
Installation notes
The K1233-36 is a front kit. Pads and rotors are replaced together, and since neither calipers nor brake lines are supplied, the originals stay on the truck.
What’s included
The K1233-36 contains slotted and cross-drilled rotors and Z36 high-friction metallic pads for the front axle.
Not included: Calipers and brake lines.









