Overview
The Omix-Ada 18674.28 is a Dana 300 transfer case shifter shaft for Jeep CJ5, CJ7 and Scrambler vehicles from 1980 to 1986. It is a direct replacement part built by Omix-Ada to original Jeep specifications, made for owners who want a shifter shaft that matches the factory component rather than a redesigned aftermarket piece.
The shaft is for Dana 300 transfer cases, so confirm your transfer case is a Dana 300 before ordering. It fits 1980-1983 CJ5, 1980-1986 CJ7 and 1981-1985 Scrambler models in the trims shown. It installs in place of the original shaft without modification.
Key features
- Direct OE replacement design, built to original Jeep specifications by Omix-Ada
- Application: Dana 300 transfer case shifter shaft
- Part number 18674.28 and UPC 804314036300 for matching against the part you removed
- Comes with a limited five year warranty.
- Direct fit for the CJ5, CJ7 and Scrambler models named in the fitment section
Checking the shift linkage
The shifter shaft connects the shift lever to the transfer case shift mechanism, so its condition affects how cleanly the transfer case changes range. Wear at the shaft or its bushings can show up as sloppy shifts, a lever that does not seat fully, or a range that is hard to find. Because the shaft moves parts inside the case, it should be inspected whenever the transfer case is opened.
Compare the new shaft with the removed one for diameter, splines and the pivot end before installing it. Install with clean parts and fresh seals where the shaft passes through the case. After installation, shift through all ranges by hand with the vehicle off to confirm smooth engagement before driving.
- Check splines for rounding or twisting
- Inspect the shaft bore and bushings
- Shift through every range before the first drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18674.28 |
| UPC | 804314036300 |
| Component | Transfer case shifter shaft |
| Transfer case | Dana 300 |
| Warranty | Limited five year warranty |
| Fitment type | Direct fit |
Vehicle fitment
It fits these vehicles:
- 1980-1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1980-1986 Jeep CJ7 (Base, Golden Hawk, Laredo, Limited, Renegade)
- 1981-1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
The CJ5 years shown start in 1980, so earlier CJ5 years are not on this list. Wrangler and Cherokee models are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shifter shaft is part of the transfer case shift linkage. Compare the new shaft side by side with the removed shaft before installing it, and confirm the transfer case is a Dana 300.
What’s included
One Dana 300 transfer case shifter shaft.









